Abstract:According to the characteristics of energy acquisition applied to tags, a monitoring circuit was added between the energy acquisition module and the tag module, and the cooperative working strategy of energy acquisition and tags was put forward based on the setting of high and low thresholds. The low threshold selection principle is to ensure that the energy storage of the energy storage module can ensure the one-time broadcasting of the tag and prevent the tag from entering the power down state to the maximum extent. The optimal value of energy storage capacitance, minimum and optimal radio frequency (RF) input power in the environment were deduced by starting from the broadcast interval and power required in the tag design goal according to the amount of energy that can be collected in the environment and the change of energy consumption required by the tag in different states. A tag based on RF acquisition was designed by using P2110B and CC2640R2F chip for verification. Test results show that the energy acquisition tag designed by this method can realize the cooperative work of energy acquisition module and tag module. The tag can carry out continuous “sleep and broadcast” cycle when the RF input power is greater than the optimal value. It can effectively prevent the label from falling into “energy deadlock”, and can adaptively switch in different working states.

Power-on-Reset Circuit in Radio Frequency Identification Tag Chip

19.5 Μw Ultra-Low-power 13.56 MHz RFID Tag Based on Transparent Zinc-Oxide Thin-Film Transistors.

Low-Power Transparent RFID Circuits Using Enhancement/Depletion Logic Gates Based on Deuterium-Treated ZnO TFTs

A Low Voltage, Low Power RF/Analog Front-End Circuit for Passive UHF RFID Tags

Low-Cost Low-Power Uhf Rfid Tag With On-Chip Antenna

A Single-Poly EEPROM with Low Leakage Charge Pump and Peripheral Circuits for Passive RFID Tag in a Standard CMOS Technology

A Two-Stage Wake-Up Circuit for Semi-Passive RFID Tag

A low power demodulator using subthreshold design

A Pure Logic Cmos Based Low Power Non-Volatile Random Access Memory For Rfid Application

A Low Voltage Low Power Oscillator Suitable for RFID Transponder

An Ultra-Low-Power Embedded EEPROM for Passive RFID Tags

An ultra-low quiescent current power-on reset circuit with DDPG method

A Low-Power, Single-Poly, Non-Volatile Memory for Passive RFID Tags

A 6.93 Mu W Wake-Up Circuit For Active Rfid Tags

Design method of electronic tag based on radio frequency energy acquisition

Circuits and Implementation of a Low-Power Embedded EEPROM Memory

A Security-Enhanced, Charge-Pump-Free, ISO14443-A-/ISO10373-6-Compliant RFID Tag with 16.2-Μw Embedded RRAM and Reconfigurable Strong PUF

Design of an EEPROM IP for RF ID's

A Low Power,Large Dynamic Range 915mhz Passive RFID Tag

A 6.93 µW wake-up circuit for active RFID Tags

Low Power Design of RFID Tags