Abstract:Wake-up receivers (WuRXs) help to significantly reduce the average power of the Internet of the Things (loT) hardware systems. To lower the “asleep” power in the idle state, the WuRX structures based on non-standard protocols have been widely studied in prior researches, which can realize a high sensitivity [1] or low power [2]. Compared to the non-standard receivers, there are more design challenges in the standard-compliant WuRXs. For example, a BLE-compliant WuRX operating in the congested 2.4GHz band should be able to handle potentially large interferers including adjacent-channel tone and image, as well as realize a high sensitivity for long-reach access. Therefore, there have been several conventional solutions for the interference-resilient BLE-compliant WuRXs: 1) Single-path down-conversion WuRXs. The interference is handled by an RF filter [3] or a low-noise LO [4] (Fig. 1, top). The WuRX in [3] utilized an FBAR filter to reject the interference from the adjacent channel, resulting in a signal-to-interference ratio (SIR) of −6dB@2MHz, where the loss of FBAR filter degraded the sensitivity to −85dBm. An LC oscillator based LO was adopted in [4] to suppress the adjacent-channel interference by −10dB, but it's at the penalty of 1.2mW power. 2) I/Q-path down-conversion WuRXs. A Hartley WuRX was designed in [5] to reject both 2MHz adjacent-channel interference and image (Fig. 1, middle), as well as improve the sensitivity to −92dBm, while the I/Q downconverters and LO generators dominated the total power consumption. Although the WuRX power was reduced to 352μW by the edge combiner based I/O LO generation, the SIR was limited to −12.5dB due to the spurs and noise accompanying the LO signal. As a result, it's difficult for the conventional WuRX structures to realize both a high SIR and low power consumption.

A 6.93 µW wake-up circuit for active RFID Tags

A 6.93 Mu W Wake-Up Circuit For Active Rfid Tags

A Two-Stage Wake-Up Circuit for Semi-Passive RFID Tag

An Ultra Low Power ASK Demodulator for Passive UHF RFID Tag

Novel Low-Voltage / Low-Power ASK Demodulator for RFID Tags

Design method of electronic tag based on radio frequency energy acquisition

Analysis and Design of a Multi-Mode Wake-Up Receiver Based on Direct Envelope Detection in Wireless Sensor Networks

Design and Implementation of an Ultra-Low Power Passive UHF RFID Tag

A Novel Demodulator For Low Modulation Index Rf Signal In Passive Uhf Rfid Tag

A Two-stage Wakeup Unit for Temperature Logger Tag

Analysis and Design of Power Efficient Semi-Passive Rfid Tag

A Low-Power RF Front-End of Passive UHF RFID Transponders

A Low Voltage, Low Power RF/Analog Front-End Circuit for Passive UHF RFID Tags

Low Modulation Index RF Signal Detection for a Passive UHF RFID Transponder

Low Power Design of UHF RFID Tag Baseband Processor

Battery Management Technique to Reduce Standby Energy Consumption in Ultra-Low Power IoT and Sensory Applications

A two stage sequence wakeup unit for temperature logger tag

A Low Power,Large Dynamic Range 915mhz Passive RFID Tag

An Interference-Resilient 120-Degree-apart Pseudo-I/Q BLE-Compliant Wake-Up Receiver Achieving-21dB SIR,-94dBm Sensitivity, and 4-D Wake-Up Signature

Low Power Design of RFID Tags

Power Management And Clock Generator For A Novel Passive Uwb Tag