Abstract:Purpose Surface configuration at the interface between two materials makes a huge difference on thermal resistance. Thermal transient analysis is a powerful tool for thermal characterization of complex structures like LEDs. The purpose of this paper is to report the influence of surface finish on thermal resistance. Design/methodology/approach Surface of heat sink was modified into two categories: machined as channel like structure; and polished using mechanical polisher and tested with 3W green LED for thermal resistance analysis. Findings The observed surface roughness of rough and polished surface was 44 nm and 4 nm, respectively. Structure function analysis was used to determine the thermal resistance between heat sink and MCPCB board. The observed thermal resistance from junction to ambient (R thJA ) value measured with thermal paste at 700 mA was lower (34.85 K/W) for channel like surface than rough surface (36.5 K/W). The calculated junction temperature ( T J ) for channel like surface and polished surface was 81.29°C and 85.24°C, respectively. Research limitations/implications Channelled surface aids in increasing bond line thickness. Surface polishing helps to reduce the air gaps between MCPCB and heat sink and also to increase the surface contact conductance. Practical implications The proposed method of surface modification can be easily done at laboratory level with locally available techniques. Originality/value Much of the available literature is only concentrating on the design modification and heat transfer from fins to ambient. There was little research on modification of top surface of the heat sink and the proposed concept would give good results and also it will make the material cost reduction as well as material too.

Measuring the thermal resistance of LED packages in practical circumstances

Analysis of thermal spreading resistance in high power LED package and its design optimization

Thermal Resistance Evaluation of High Power LED

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

Thermal Resistance Measurement of Light-Emitting Diodes Based on Photo-Electro-thermal Theory

Study of LED Thermal Resistance and TIM Evaluation Using LEDs with Built-in Sensor

A New Non-Contact Method Based on Relative Radiation Intensity for Determining Junction Temperature of LEDs

Thermal Analysis and Design of High-Power LED Street Light

Thermal Analysis of Light-Emitting Diodes Based on Photo-Electro-thermal Relationship

The performance of compact thermal models for LED package

Experimental Study of Measuring LED's Temperatures Via Thermocouple

A Compact Thermal Model to Predict the Junction Temperature of High Power Light Emitting Diode Package

Thermal Measurement of Power LED by Structure Function

Analysis of luminous efficiency of power LED

Measurement of the thermo-optic parameters of power LED on pulse current

Analysis and Measurement of Thermal Resistance Induced by LED Bonding

A Method to Measure and Analyze LED’s Thermal Structure Based on Curve Fitting

High Power LED Thermal Performance Test Analysis and Its Research Methods

Thermal resistance studies of surface modified heat sink for 3W LED using transient curve

Study on The Measurement for the Thermal Resistance of Power LED

Junction Temperature Measurement and Luminous Properties Research of High-Power LED