Abstract:Shock tube ignition delay times and species time history measurements for Primary Reference Fuels (PRFs) such as normal heptane provide targets for the validation of combustion models, which in turn are used to develop more fuel-efficient engines that have smaller environmental footprints. However, a review of the literature has revealed that most of the shock tube ignition delay time and species measurement data for normal heptane have been obtained at elevated pressures, rather than at relatively low pressures where many other important experimental techniques such as jet-stirred reactors and flow reactors can provide corroborating results. One central problem preventing previous shock tube studies from examining first-stage ignition at these lower pressures was that ignition times were too long under these conditions to be measured within the available shock tube test times. To address this issue, recent advances in shock tube techniques for achieving long uniform test times have been applied in order to measure low-pressure first-stage ignition times of normal heptane together with normal heptane fuel time-history records at times up to about 30 ms. These measurements were performed in the Negative Temperature Coefficient (NTC) region (T = 664 - 792 K) in lean mixtures (21%O-2/Ar, equivalence ratio phi = 0.5) at pressures of roughly P = 3.5 atm using both the conventional and Constrained Reaction Volume (CRV) shock tube filling strategies. The data have been used to evaluate the performance of several combustion models, have been compared with other higher-pressure shock tube first-stage ignition times in n-heptane/20-21%O-2 mixtures found in the literature, and have been fit using a two-zone Arrhenius model for first-stage ignition delay times. The results showed that some combustion models yield ignition delay time predictions that differ from the experimental results by as much as an order of magnitude, that under these conditions n-heptane first-stage ignition times scale by roughly P-0.71 but are insensitive to phi, and that the fraction of fuel remaining after first-stage ignition increases with increasing initial experimental temperature. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Shock Tube Study of Kerosene Ignition Delay at High Pressures

Study on Ignition Delay of Kerosene Aerosol in Shock Tube

Shock Tube Study on Auto-Ignition Characteristics of Kerosene/air Mixtures

Shock Tube Study on Auto-ignition Delay of Kerosene Aerosol and its Cracked Mixture

Ignition Delay Times of Kerosene (Jet-A)/Air Mixtures

Shock-Tube Study on Ethylcyclohexane Ignition

Shock tube ignition delay time measurements in propane/O2/argon mixtures at near-constant-volume conditions

The ignition delay measurement of atomized kerosene air mixture in an aerosol shock tube

Shock Tube Study of Methylcyclohexane Ignition over a Wide Range of Pressure and Temperature

Shock Tube Measurements and Kinetic Study on Ignition Delay Times of Lean DME/n-Butane Blends at Elevated Pressures

Shock Tube and Kinetic Study of C2H6/H2/O2/Ar Mixtures at Elevated Pressures

Experimental Investigation of Ignition Delay Time of N-Heptane in Shock Tube

Aerosol Shock Tube Designed for Ignition Delay Time Measurements of Low-Vapor-Pressure Fuels and Auto-Ignition Flow-Field Visualization

Ignition, puffing and sooting characteristics of kerosene droplet combustion under sub-atmospheric pressure

Shock Tube Study of Normal Heptane First-Stage Ignition Near 3.5 Atm

Experimental Investigation on Auto-Ignition Characteristics of Kerosene Spray Flames

Shock Tube Study of Ignition-Delay Measurements and Kinetic Mechanism Research for Syngas

Shock-tube measurements of ignition delay times for the ethane/dimethyl ether blends

Experimental and Kinetic Study on Ignition Delay Times of Lean N -Butane/hydrogen/argon Mixtures at Elevated Pressures

Shock tube measurements and kinetic investigation on the ignition delay times of methane/dimethyl ether mixtures

Shock-tube Study of the Autoignition of N-Heptane/toluene/air Mixtures at Intermediate Temperatures and High Pressures