Abstract:When fault occurs on cross-coupling autotransformer (AT) power supply traction network, the up-line and down-line feeder circuit breakers in the traction substation trip at the same time without selectivity, which leads to an extended power failure. Based on equivalent circuit and Kirchhoff's current law, the feeder current characteristic in the substation, AT station and sectioning post when T–R fault, F–R fault, and T–F fault occur are analyzed and their expressions are obtained. When the traction power supply system is equipped with wide-area protection measurement and control system, the feeder protection device in each station collects the feeder currents in other two stations through the wide-area protection channel and a wide-area current differential protection scheme based on the feeder current characteristic is proposed. When a short-circuit fault occurs in the power supply arm, all the feeder protection devices in each station receive the feeder currents with time stamp in other two stations. After data synchronous processing and logic judgment, the fault line of the power supply arm can be identified and isolated quickly. The simulation result based on MATLAB/Simulink shows that the power supply arm protection scheme based on wide-area current differential has good fault discrimination ability under different fault positions, transition resistances, and fault types. The verification of measured data shows that the novel protection scheme will not be affected by the special working conditions of the electrical multiple unit (EMU), and reliability, selectivity, and rapidity of relay protection are all improved.

Software and Hardware Design of New Type Traction Power Supply System Protection Device

Relay protection simulation software of DC traction power system of urban rail transit

Discussion of the Grounding, Electricity Leakage and Isolation Protection in the DC600 V Power Supply System

Design of a Power Supply Module for Electric Vehicle Charging Station

Fault Analysis and Protection in Flexible DC Traction Power Supply System

Research on the Control and Protection Device in DC Traction Power Supply System

Design of Main Wiring of Traction Power Supply System for Urban Rail Transportation

Analysis of Urban Rail DC Short Circuit Fault and Vehicle-Network Protection Coordination Based on Transient Characteristics

Research on the control and protect system in DC power distribution system

Research on the Design Method of Railway Traction Power Supply Cable under Harmonic Restraint

Analysis of Short-circuit Fault in DC Traction Power Supply System for Urban Mass Transit

Design of Power Supplies Used in Safety-Critical Computer Platform

Research of Metro DC Microcomputer-Based Feeder Protection Device

Stability improvement control for metro traction drive system

Power Flow Algorithm for Traction Power Supply System of Electric Railway Based on Locomotive and Network Coupling

Design and Simulation of an Intelligent Current Monitoring System for Urban Rail Transit

Research on Short-Circuit Characteristics of Subway DC Traction Power Supply System

Power supply arm protection scheme of high-speed railway based on wide-area current differential

Architecture of Urban Rail Transit Power Supply Based on PET Braking Energy Feedback

Crossing Power Restraint under Bidirectional Traction Substation Converter in Urban Rail Transit with Multiple Reflux Paths Coupling

DC Autotransformer-Based Traction Power Supply for Urban Transit Rail Potential and Stray Current Mitigation