Abstract:The double-ended excitation self-balancing bridge excitation method is a capacitance measurement method with rather a high measurement accuracy currently. However, the reference impedance of the electric bridge limits the traditional self-balancing excitation measurement method, making it difficult to achieve high accuracy and a wide range of capacitance sensor measurements. In the proposed paper, frequency adjustment method is introduced to enable impedance matching between the measured capacitance and the reference resistance. The measurement range is broadened as well as maintaining the accuracy of the capacitance measurement. The measurement circuit is composed of a reference resistor, a bridge in series with the measured capacitance and an operational amplifier follower circuit. First, we roughly measure the input impedance of the operational amplifier and the capacitive reactance of the capacitance under test using a two-step excitation method. Then, the best excitation frequency is calculated to match the reference resistor according to the capacitive reactance under test, and the input impedance of the operational amplifier is re-estimated with the best frequency. Finally, we complete the accurate measurement of the capacitive reactance under test through the use of dual excitation. The experimental results demonstrate the method's high accuracy measurement within the range of 1.6pF to 16nF, with the reference resistance set at 1MΩ and the excitation frequency adjusted between 10-100kHz. Additionally, dual excitation stability testing verifies relative standard deviations in the range of 0.01% to 0.12%. Experiments on filter capsule sensing detection show that the proposed frequency adjustment measurement method can perform highly sensitive capacitive sensing measurements under the influence of parasitic effects.

An Auto Source Balance Method of High Precision AC Bridge

A New Capacitance-to-Frequency Converter for On-Chip Capacitance Measurement and Calibration in CMOS Technology

Development of high precision distortion meter

A High-Speed Bioelectrical Impedance Spectroscopy System Based on the Digital Auto-Balancing Bridge Method

Automatic Measurement of the Equivalent Static Capacitance of Ultrasonic Transducers for Dynamic Matching

A Model-Free Capacitor Voltage Balancing Method for Multilevel DAB Converters

New method for improving the measurement accuracy of AC/DC Kelvin bridge

Dual excitation self-balancing capacitance measurement method based on frequency adjustment

Wide bandwidth cell impedance spectroscopy based on digital auto balancing bridge method

A Novel System for Measuring Alternating Current Impedance Spectra of Series-Connected Lithium-Ion Batteries with a High-Power Dual Active Bridge Converter and Distributed Sampling Units

Improving Source-Follower Buffer For High-Speed Adc Testing

Calibration Method of a Wideband AC Resistance Voltage Divider Based on an Equivalent Model

A New Technology of the Salinity Measurement

Resonant frequency detection and adjustment method for a capacitive transducer with differential transformer bridge.

A high-accuracy capacitor condition monitoring scheme at low sample frequency based on improved current reconstruction method

The Measurement of High-Precision Air Resistance Using QJ55 DC-Comparator Bridge (Improved)

An Automatic Compensation Method for Measuring the AC Loss of a Superconducting Coil

A New Automatic Tuning Principle and Its Application of Arc-Suppression Coil with Magnetic Bias

A High-Precision Sensor Based on AC Flux Cancellation for DC Bias Detection in Dual Active Bridge Converters

High precision low-frequency AC signal source for ADC dynamic performance test system

Anti-interference Measurement Method of Zero Sequence Capacitance of Transmission Lines Based on Harmonic Component