Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Heat leak of a 68kA HTS current lead for ITER

Research on Improving the System Sensitivity for Hot Helium Leak Test

Hot Helium Leak Test of ITER Blanket Shield Block

Study on Heat Leakage of Current Leads of 300 Kva HTS Transformer

China's Progress on Hot Helium Leak Test of ITER Shield Blocks

Test Results of ITER 52-Ka HTS Current Lead Prototypes

Cold Performance Tests of the ITER 68 Ka HTS Current Lead Prototypes

Test Facility and Results of ITER PF4 Current Leads

Progress of High Heat Flux Component Manufacture and Heat Load Experiments in China

Development of HTS Current Leads for the ITER Project

Heat transfer coefficient calculation for analysis of ITER shield block using CFX and ANSYS

Design and heat leak analysis of a HTS DC cable system

Heat Transfer Capability Simulation of High-Temperature Heat Pipe in Supersonic Vehicle Leading Edge Applications

THE CURRENT LEADS AND THEIR ELECTRICAL INSULATION & THERMAL CONDUCTION FOR 35kJ SMES

Numerical simulation of the temperature field in the ITER Chinese helium cooled solid breeder test blanket module

Influence of heat treatment excursion on critical current and residual resistivity ratio of ITER Nb3Sn strands

Numerical Simulations of the Temperature Field in the Breeding Sub-Module of the ITER Chinese Helium Cooled Solid Breeder Test Blanket Module

Three-Dimensional Numerical Simulation of Temperature Field and Helium Flow Field in ITER China TBM

Optimization of Kiloampere Peltier Current Lead Using Orthogonal Experimental Design Method

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Design and test of insulating and sealing structure of high current heater's electrical penetration assembly