Abstract:The Experimental Advanced Superconducting Tokamak (EAST) research program concentrates on demonstrating steady-state high-performance H-mode operations with ITER-like tungsten divertor. Calorimetry was applied to actively water-cool the plasma facing components (PFCs) by increasing the water temperature for power balance investigation. Considering the energy balance of EAST long-pulse high-performance discharges with upper single null (USN) con?guration, thus far, approximately 78% of the injected energy could be accounted for. The method of estimation of heat flux on upper tungsten divertor target with a high time- and spatial-resolved infrared camera has been developed, and the sum of its heat load was found to be significantly consistent with that measured through calorimetry. The record longest steady-state H-mode plasma #73 999 was sustained for up to 101.2 s with net injected energy exceeding similar to 0.25 GJ in the USN configuration. Heat load analysis of this discharge using calorimetric measurement indicates that the modification of heat load distribution was observed and this was induced by a slight change in the magnetic configuration. Not all temperature increments in the five cooling water modules reached the saturated state for the 100 s level discharge, which means that 100 s timescales are insufficient as compared to the thermal transport timescale in the targeted PFCs. The heat load on the tungsten divertor targets is not evenly distributed with the ratio of similar to 2 in favour of the outer divertor.The experimental results and analysis of the physics involved in these USN configuration discharges are reported and discussed.

Cold Performance Tests of the ITER 68 Ka HTS Current Lead Prototypes

Test Results of ITER 52-Ka HTS Current Lead Prototypes

Test Facility and Results of ITER PF4 Current Leads

Development of HTS Current Leads for the ITER Project

China’s Technological Achievements on ITER Enhanced Heat Flux First Wall in the Pre-Pa Qualification

China's Progress on Hot Helium Leak Test of ITER Shield Blocks

Hot Helium Leak Test of ITER Blanket Shield Block

Progress of High Heat Flux Component Manufacture and Heat Load Experiments in China

Design and Test Performance of 2g Pancake Coils for Hts Dc Induction Heater Prototype

Test System Upgrade for ITER Current Lead Series Production at ASIPP

Current Progress of Chinese HCCB TBM Program

Development of Testing Device for Critical Current Measurements for HTS/LTS

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Full Scale Prototype Research and Development of the Iter Pf Converter Unit

Manufacture and testing of the CTB&SBB thermal shield for the ITER magnet feeder system

Development of the Coil Terminal Boxes for the ITER Magnet Feeder Systems

Qualification Test Results of the KSTAR Superconducting Coils from the Construction to the Commissioning Steps

Preliminary Design Study on Non-Twisted HTS Conductor for Fusion Applications

Development and Testing of a 300-Kvar HTS Synchronous Condenser Prototype

Manufacture and Testing of Pre-prototype HTS Twisted Stack Slotted-Core Cable

Research and Development of the High-Power High-Current Polodial Field Converter Module