Abstract:The Institute of Plasma Physics, Chinese Academy of Sciences was contracted by General Atomics Company to develop a superconducting feeder system containing a pair of 50-kA high-temperature superconducting (HTS) current leads for ITER central solenoid magnet test. These HTS current leads (HTSCL) are based on the previous ITER lead design experiences. However, the vertical assembly design of HTSCL which is different from ITER's horizontal assembly causes the water leakage in the insulation flange during the initial phase. Some improvements were recognized and expected to avoid the potential risk for further prototypes and series production of ITER leads. Some development experiences are shared in this paper. The HTS current leads contain BiSCCO AgAu matrix tapes to minimize the heat load to 4.5 K end. Its resistive part is cooled by 50-K helium. In the HTS part, the conduction cooling is adopted. The HTS current leads were integrated in the feeder system to perform 4.5-K full current test. The factory acceptance test was implemented to verify the high-voltage and thermodynamic performances. The maximum current of 55 kA was achieved. The test indicates that the helium mass flow consumption is 3.3 g/s per lead and the loss of flow accident time is approximate to 10 min at the nominal current with the stoppage of 50-K helium. The insulation flange passed the high-voltage test of 15 kV, while the leakage current is less than 1 mA after the improvement. More detailed test results will be shown in this paper.

Test System Upgrade for ITER Current Lead Series Production at ASIPP

New Facility for the Cryogenic Test of ITER Current Leads at ASIPP

Development of ITER HTS Current Lead at ASIPP

China’s Technological Achievements on ITER Enhanced Heat Flux First Wall in the Pre-Pa Qualification

Design and Technology Preparation for the ITER HTSCL

Test Results of ITER 52-Ka HTS Current Lead Prototypes

Progress of ITER Procurement in China

Test Facility and Results of ITER PF4 Current Leads

Development and Qualification of ITER Current Lead Electrical Insulation

Manufacture and Test of ITER 10 Ka HTSCL Prototypes

Manufacture And Test Of The Iter Tf Type Hts Current Lead Prototypes

Cold Performance Tests of the ITER 68 Ka HTS Current Lead Prototypes

Progress of High Heat Flux Component Manufacture and Heat Load Experiments in China

Mock-up Qualification and Prototype Manufacture for ITER Current Leads

Design Evolution and Integration of the ITER In-Vessel Components

Full Scale Prototype Research and Development of the Iter Pf Converter Unit

R&D on 52-kA HTS Current Lead at ASIPP

ITER PF4 CFT 80 K Cold Test at ASIPP

Factory Acceptance Test of 50-Ka HTS Current Leads for the ITER CS Magnet Test Application

Development of HTS Current Leads for the ITER Project

Design and Test of 10 Ka HTSCL for ITER