Abstract:Abstract Liquid crystal thermography and infrared thermography techniques are typically employed to measure detailed surface temperatures, where local heat transfer coefficient (HTC) values are calculated by employing suitable conduction models. One such practice, which is very popular and easy to use, is the transient liquid crystal thermography using one-dimensional semi-infinite conduction model. In these experiments, a test surface with low thermal conductivity and low thermal diffusivity (e.g. acrylic) is used where a step-change in coolant air temperature is induced and surface temperature response is recorded. An error minimization routine is then employed to guess heat transfer coefficients of each pixel, where wall temperature evolution is known through an analytical expression. The assumption that heat flow in the solid is essentially in one-dimension, often leads to errors in HTC determination and this error depends on true HTC, wall temperature evolution and HTC gradient. A representative case of array jet impingement under maximum crossflow condition has been considered here. This heat transfer enhancement concept is widely used in gas turbine leading edge and electronics cooling. Jet impingement is a popular cooling technique which results in high convective heat rates and has steep gradients in heat transfer coefficient distribution. In this paper, we have presented a procedure for solution of three-dimensional transient conduction equation using alternating direction implicit method and an error minimization routine to find accurate heat transfer coefficients at relatively lower computational cost. The HTC results obtained using 1D semi-infinite conduction model and 3D conduction model were compared and it was found that the heat transfer coefficient obtained using the 3D model was consistently higher than the conventional 1D model by 3–16%. Significant deviations, as high as 8–20% in local heat transfer at the stagnation points of the jets were observed between h1D and h3D.

Heat transfer coefficient calculation for analysis of ITER shield block using CFX and ANSYS

Analysis and Optimization of Cooling Channels in ITER Blanket Module

Electromagnetic analyses and optimization for slit configuration of ITER blanket shield block

Analysis of Turbulent Heat Transfer in Rectangular Flow Channels Inside the First Wall of Blanket Modules

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Determination of Heat Transfer Coefficient

A Novel Numerical Method to Evaluate the Heat Transfer Characteristics of Complicated Cicc Structures

Preliminary Thermal Mechanical Analysis of the Equatorial Thermal Shield for Iter

Heat transfer coefficient study for air quenching by expenriment and CFD modeling

Conjugate Heat Transfer Analysis Of A High Pressure Air-Cooled Gas Turbine Vane

Analytical Solution of Heat Conduction for Hollow Cylinders with Time-Dependent Boundary Condition and Time-Dependent Heat Transfer Coefficient

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Quantification of Heat Transfer Coefficient in Transient Liquid Crystal Experiments

A FEM-Based Inverse Calculation Method for Determination of Heat Transfer Coefficient in Liquid Quenching Process

A CFD Method for Thermal-Hydraulic Calculation of Pebble Bed HTGRs

Robust methodology for determination of heat transfer coefficient distribution in convection

An Inverse Estimation of Frozen Sand Mold-Melt Heat Transfer Coefficient in the Solidification of A356 Alloy

Study of filtered interphase heat transfer using highly resolved CFD–DEM simulations

Application of Heat Transfer Coefficient Criteria Formulas for the Conjugate Heat Transfer Analysis of a Gas Turbine

Heat Transfer Simulation of Fuel Transport Cask for High Temperature Gas Cooled Reactor

Determination of heat transfer coefficient in a T-shaped cavity by means of solving the inverse heat conduction problem

Numerical Analysis of Heat Transfer Characteristics of External Cooling Channel of the Lower Head

Numerical simulation on conjugate heat transfer of turbine cascade