Abstract:As turbine inlet temperature gets higher and higher, thermal barrier coating (TBC) is more and more widely used in turbine blades. For turbine blades with TBC, it is of great significance to evaluate the temperature distribution of its substrate metal quickly and accurately, especially during the design stage. With different degrees of simplification such as whether to consider the change of the geometric size of the fluid domain by TBC and whether to consider the planar heat conduction in TBC, three different methods used in conjugate heat transfer (CHT) simulation to model the TBC of the turbine blades have been developed and widely used by researchers. However, little research has been conducted to investigate the influence of the three methods on the temperature distribution of turbine blade. To fill this gap, three geometric models were designed. They are a solid conduction model with a substrate metal layer and a TBC layer, a transonic turbine vane with internal cooling and TBC, and a plate cylindrical film hole cooling model with TBC. Different methods were used in these geometric models and their differences were carefully analyzed and discussed. The result shows that for the conduction model used in this paper, with the same TBC surface temperature distribution, the difference between the three methods is very small and can be ignored. For a transonic turbine vane with internal cooling, regarding the local maximum temperature of the substrate-TBC interface, the largest difference between the method in which TBC is considered as a thermal resistance or a virtual layer of cells and the method in which three-dimensional heat conduction equation of TBC is solved occurs at the trailing edge. The difference near the leading edge is below 2 K. When employed to the film cooling model, the difference of the laterally averaged temperature of the substrate-TBC interface can be 8 K which is mainly due to the change of the length to diameter ratio of the film cooling hole by TBC. If the substrate thickness is reduced by the thickness of TBC when three-dimensional heat conduction equation of TBC is solved, the temperature difference between the three methods will be quite limited.

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Quantification of Heat Transfer Coefficient in Transient Liquid Crystal Experiments

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Determination of Heat Transfer Coefficient

A Computational Method to Solve for the Heat Conduction Temperature Field Based on Data-Driven Approach

A numerical method for two-dimensional nonlinear transient inverse heat conduction problems for orthotropic material

Measurement of Boiling Heat Transfer Coefficient in Liquid Nitrogen Bath by Inverse Heat Conduction Method

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

Analytical Solution of Heat Conduction for Hollow Cylinders with Time-Dependent Boundary Condition and Time-Dependent Heat Transfer Coefficient

A two-dimensional inverse heat conduction problem for simultaneous estimation of heat convection coefficient, fluid temperature and wall temperature on the inner wall of a pipeline

A FEM-Based Inverse Calculation Method for Determination of Heat Transfer Coefficient in Liquid Quenching Process

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Estimation of Surface Temperature and Heat Flux over a Hollow Cylinder and Slab using an Inverse Heat Conduction Approach

Interactive Influence of Conduction–Convection–Radiation on Heat Transfer from a Discretely and Non-Identically Heated Electronic Gadget

Accurate transient heat flux from simple treatment of surface temperature distribution in the semi-infinite case

Robust methodology for determination of heat transfer coefficient distribution in convection

A two-dimensional inverse heat conduction problem in estimating the fluid temperature in a pipeline

A general numerical method for solving the three-dimensional hyperbolic heat conduction equation on unstructured grids

Comparative Study on Different Methods for Prediction of Thermal Insulation Performance of Thermal Barrier Coating Used on Turbine Blades

Inverse Heat Conduction Problem for Estimating Heat Flux on A Triangular Wall

Cfd -Based Modelling On Inter Facial Heat Transfer For Water Quenching

Determining mainstream reference temperature using the non-dimensional temperature analysis in the transient liquid crystal technique

Evaluation of interfacial heat transfer coefficient based on the experiment and numerical simulation in the air-cooling process