Time-based and volume-based sampling for flow-injection on-line sorbent extraction graphite furnace atomic absorption spectrometry

Bernhard Welz,Xuefeng Yin,Michael Sperling

DOI: https://doi.org/10.1016/0003-2670(92)80229-Z

IF: 6.911

1992-01-01

Analytica Chimica Acta

Abstract:Fow-injection on-line preconcentration systems for graphite furnace atomic absorption spectrometry are complicated by the low eluate volume of typically less than 50 μl which can be accommodated in a graphite tube or on a graphite platform. Even when a column with an extra small capacity of 15 μl was used, it was found impossible to elute the sorbed analyte completely with an eluate volume that was compatible with the capacity of the graphite furnace. Two approaches for introducing only the most concentrated fraction of the eluate into the graphite tube while discarding the rest were investigated and compared: controlling the time interval for collection and introduction of the eluate fraction into the furnace tube (time-based sampling), and collection of the eluate fraction of interest in thin tubing of fixed volume, followed by introduction of this fraction into the tube using a low flow of air (volume-based sampling). Cadmium, copper, lead and nickel were the analyte elements investigated. A 15–30% greater enhancement factor was obtained for volume-based sampling because dispersion was interrupted during sample injection by air segmentation. The short- and long-term reproducibility were also better for volume-based sampling because variations in the pump tubing had no influence on the eluate volume introduced. These combined effects resulted in an improvement in detection limits of the four elements by factors of 1.3–2.0. Sample throughput (23 h−1), sample consumption (3 ml min−1 and reagent consumption were the same for both approaches. There were no significant differences in the accuracy and precision of the two techniques in the analysis of sea water, estuarine water and river water standard reference materials.