Effect of coal-over-coal reburn on furnace temperature and heat flux distributions in 1MW tangentially fired furnace

Sen Li,Tongmo Xu,Qulan Zhou,Houzhang Tan,Shien Hui
DOI: https://doi.org/10.1016/j.ijthermalsci.2009.07.007
IF: 4.779
2010-01-01
International Journal of Thermal Sciences
Abstract:The furnace temperature and heat flux distributions of 1MW tangentially fired furnace were studied during coal-over-coal reburn, and the influences of the position of reburn nozzle and reburn fuel fraction on furnace temperature and heat flux distributions were investigated. Compared with the baseline, the flue gas temperature is 70–90°C lower in primary combustion and 130–150°C higher at furnace exit, and the variations of the flue gas temperature distributions along furnace height are slower. The temperature distribution along the width of furnace wall decreases with the increase of the relative furnace height. In the primary combustion zone and the reburn zone, the temperature and heat flux distributions of furnace wall are much non-uniform and asymmetric along the width of furnace wall, those of furnace wall in the burnout zone are relatively uniform, and the temperature non-uniformity coefficients of the primary combustion zone, the reburn zone and the burnout zone are 0.290, 0.100 and 0.031, respectively.
What problem does this paper attempt to address?