Abstract:Numerical simulation was performed on the combustion and contamination generation process under the original scheme and four retrofit schemes with different positions of coal reburning injector using conventional pulverized coal as reburning fuel with the rated load in a 410 t/h tangentially fired furnace in a domestic thermal power plant with CFD software platform. Results show that thermal NOx can be restrained since the highest temperature decreases when the volume heat load qv of burner zone decreases due to extending the burner zone in the reburning retrofit. The better NOx reduction can be achieved since the lower NOx concentration from the main combustion zone where the low oxygen combustion can restrain the NOx. The lower position of reburning injector, the less NOx reduction can be achieved due to the disturbance effect from main combustion zone. On the other hand, the higher position of reburning injector, the less NOx reduction, the higher temperature of the outlet of furnace and the higher unburned carbon of fly ash can also be achieved due to the shorter settle time of reburning coal, but the better NOx reduction can be achieved through choosing an appropriate position of reburning injector. The NOx reduction of 47.66% can be achieved by using low oxygen primary combustion zone, appropriate position of reburning injector, and OFA. Further more, all parameters of the boiler run well and thermal efficiency of the boiler is increased slightly. Therefore, the satisfied NOx reduction can be achieved using conventional pulverized coal as reburning fuel for the low ash content and flammable bituminous coals. Engineering testing shows that the results from numerical simulation are in conformity with real operation condition.

Optimization of coal reburning in a 1MW tangentially fired furnace

Experimental Study on Micronized Coal Reburning for a 200MW Coal-fired Boiler

NUMERICAL SIMULATION OF COMBUSTION PROCESS IN A 200MW TANGENTIALLY FIRED FURNACE TO STUDY FURNACE RECONSTRUCTION

STUDY OF COAL RANK AND FINENESS ON NOx REDUCTION WITH COAL REBURNING TECHNOLOGY

Numerical Simulation of Pulverized-coal Reburning Technology for a Large-sized Lignite-fired Boiler

Experimental Study on Coal Reburning Dynamic Process for NOx Reduction

Experiment and Mechanism Investigation on Advanced Reburning for NO(x) Reduction: Influence of CO and Temperature.

Experimental Research on NOx Reduction in Furnace with Coal Reburning

Pulverized coal reburning in a semi-industrial furnace

Experimental Study and Numerical Simulation on Tertiary Air Reburning with Different Micronized Coal Content

Experimental Study on Reducing Furnace NO_x Emission Through Coal Water Slurry Reburning

An Experimental Study on Controlling CO and N2O Emission of Boiler Through Pulverized Coal Reburn

Combustion System Renovation of 125MW Unit for Enhancing Coal Suitability and the Influence on NOx Emission

Parametric study of reburning of nitrogen oxide for superfine pulverized coal

TEST AND STUDY ON NOx REDUCTION WITH MICRONIZED COAL-DUST REBURNING

Main Influencing Factor of Conventional Pulverized-Coal Reburning

Selection of Position of Pulverized Coal Reburning Injector in Low NO_x Retrofit Schemes

Detailed in-furnace measurements with reburning of superfine pulverized coal in high CO2 concentration

Dynamics Mechanism Governing a NO Reduction Reaction During the Reburning of Superfine Pulverized Coal

Investigations on combustion optimization and NOX reduction of a 600-MWe down-fired boiler: Influence of rearrangement of tertiary air and jet angle of secondary air and separated over-fire air

Experimental Study for Nox Reduction Using Four Chinese Pulverized Coals