Abstract:The emission of NOx can causes serious environmental pollution and endangers human health. In recent years, the selective catalytic reduction of NO with NH3 (NH3‐SCR) technology has been widely studied and adopted to reduce the production and emissions of NOx during many technologies. A series of Mn–Ce–Cox/Ti–C,N catalysts were prepared by the impregnation method, and low‐temperature NH3–SCR was studied. The results show that support modification (Ti–C,N) can broaden the operation temperature window of the catalyst (NO conversion >95%: Mn–Ce/TiO2 catalyst, 160–320 °C; Mn–Ce/Ti–C,N catalyst, 140–320 °C). The doping of Co further improves the low‐temperature NH3‐SCR of the catalyst. When n(Co):n(Ti) = 0.05, the catalyst has the best catalytic performance with the NO conversion reaches 100% at 100 °C. Temperature‐programmed reduction (H2‐TPR) and temperature‐programmed desorption (NH3‐TPD) results showed that Ti–C,N can improve the redox ability but reduces the surface acidity. Co‐doping has no effect on surface acidity, but the redox ability is further improved. A suitable amount of Co‐doping is beneficial to the optimal catalytic activity of Mn–Ce–Co0.05/Ti–C,N catalyst. This suggests a balance between redox properties and surface acidity. Especially for the strong redox ability, it can promote the oxidation of NO to NO2, and promote low‐temperature NH3‐SCR through the ‘fast SCR’ pathway. X‐ray photoelectron spectroscopy results of the highest chemisorbed oxygen (Oα) concentration and relative atomic ratio (Mn4+/Mnn+, Ce3+/Cen+ and Co3+/Con+) confirmed the above conclusion. Both the Langmuir–Hinshelwood (L‐H) and Eley–Rideal (E‐R) mechanisms occurred in the NH3‐SCR reaction over the Mn–Ce–Co0.05/Ti–C,N catalyst. © 2021 Society of Chemical Industry

Low-temperature scr of no with nh3 on Mn-based catalysts modified with cerium

Investigation on the redox/acidic features of bimetallic MOF-derived CeMOx catalysts for low-temperature NH3-SCR of NOx

Catalytic performance of MnO 2-CeO 2/Ti 0.25Zr 0.25Al 0.5O 1.75 monolith catalyst for low temperature selective catalytic reduction of NO with NH 3

Mnox/Ceo2/Sio2 Catalysts Prepared by Adsorption Phase Reaction Technique for Selective Catalytic Reduction of Nox at Low-Temperature

Low-temperature SCR of NO with NH3 over AC/C Supported Manganese-Based Monolithic Catalysts

C,N‐modified TiO2‐supported Mn–Ce–Cox‐based Catalyst for Low‐temperature NH3‐SCR

Catalytic performance of CeO2-NPs and α-MnO2 mixed oxides catalysts for low-temperature NH3-SCR of NO

Ceria modified MnOx/TiO2 as a superior catalyst for NO reduction with NH3 at low-temperature

Mechanism and Kinetics Study on Low-Temperature NH3-SCR over Manganese–Cerium Composite Oxide Catalysts

CeO 2 Catalysts for NH 3 ‐ SCR at Low Temperatures

Low-temperature Selective Catalytic Reduction of NO with NH3 over MnCe Oxides Supported on TiO2 and Al2O3: A Comparative Study

Comparison of Mn doped CeO2 with different exposed facets for NH3-SCR at low temperature

Si-modified Mn-Ce oxide catalyst for selective catalytic reduction of NOx with NH3 at low temperature

Improvement of Activity and SO2 Tolerance of Sn-Modified MnOx–CeO2 Catalysts for NH3-SCR at Low Temperatures

C,N ‐modified TiO 2 ‐supported Mn–Ce–Co x ‐based catalyst for low‐temperature NH 3 ‐SCR

Low-temperature selective catalytic reduction of NO with NH3 over Mn–Ce–Ox/TiO2: a comparison between catalyst preparation methods

Novel Homogeneous and Mesoporous MnOx-Doped Ceria Nanosheets As Catalysts for Low-Temperature Selective Catalytic Reduction

Highly Dispersed Surface Active Species of Mn/Ce/TiW Catalysts for High Performance at Low Temperature NH3-SCR

Low Temperature Selective Catalytic Reduction of NOx with NH3 over Amorphous MnOx Catalysts Prepared by Three Methods

Superior Oxidative Dehydrogenation Performance toward NH<sub>3</sub> Determines the Excellent Low-Temperature NH<sub>3</sub>-SCR Activity of Mn-Based Catalysts

Enhancing low-temperature NH3-SCR performance of Fe–Mn/CeO2 catalyst by Al2O3 modification