Abstract:The excellent mechanical and physical properties of Ti6Al4V titanium alloy make it a good candidate material for a broad range of applications, with special relevance for the aerospace industry. As a difficult-to-cut alloy, it represents a great challenge to improve its machinability and surface integrity while simultaneously avoiding the high time consuming and cost of the experiments. Modelling and simulation of the machining process offer a cost-effective method to investigate the machining process. In this work, an orthogonal cutting model of Ti-6Al-4 V alloy was developed and used to simulate the major cutting outcomes, including: forces, temperature distribution, chip geometry, chip compression ratio and residual stresses in the machined surface and subsurface. This cutting model includes a constitutive model accounting for the state of stress and the strain-rate effects on the mechanical behaviour (plasticity and damage) of Ti-6Al-4 V alloy in metal cutting. In addition, Zorev contact model is used to simulate the contact stresses at both tool-chip and tool-workpiece interfaces. The proposed cutting model could predict relatively well the major cutting outcomes for seven cutting conditions. The difference between simulated and experimental cutting forces is less than 14%, but the predicted thrust force is underestimated about 53% in maximum. The difference between simulated and measured maximum compressive residual stresses in cutting and transversal directions can reach in average about 17% and 36%, respectively. The maximum difference between predicted and measured thicknesses of the layer affected by residual stresses is less than 19%. This study highlights several critical points affecting the thrust force and the residual stress predictions, which should be considered in future developments of cutting models.

Determination of the Flow Stress of Ti6Al4V Based on Cutting Experiment and Optimization

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Numerical simulation on surface residual stress for titanium alloy

Finite element simulations of Ti6Al4V titanium alloy machining to assess material model parameters of the Johnson-Cook constitutive equation

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

Inverse determination of improved constitutive equation for cutting titanium alloy Ti-6Al-4V based on finite element analysis

A Hybrid Cutting Force Model for High-speed Milling of Titanium Alloys

Machining mechanism and stress model in cutting Ti6Al4V

Machining Simulation of Ti6Al4V Using Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the State of Stress

Constitutive Model and Cutting Simulation of Titanium Alloy Ti6Al4V after Heat Treatment

Subroutine Embedding and Finite Element Simulation of the Improved Constitutive Equation for Ti6Al4V during High-Speed Machining

Modelling orthogonal cutting of Ti-6Al-4 V titanium alloy using a constitutive model considering the state of stress

A New Microstructure-Sensitive Flow Stress Model for the High-Speed Machining of Titanium Alloy Ti–6Al–4V

Microstructure Sensitive Flow Stress Based on Self Consistent Method

Simulation of Material Side Flow Using a 3D Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the Stress State

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Stress-Strain Curves and Modified Material Constitutive Model for Ti-6Al-4V over the Wide Ranges of Strain Rate and Temperature

On the selection of an empirical material constitutive model for the finite element modeling of Ti6Al4V orthogonal cutting, including the segmented chip formation

A New Flow Stress Model Based on Arrhenius Equation to Track Hardening and Softening Behaviors of Ti6Al4V Alloy