Abstract:Numerous adsorbents have been applied for Heavy Metals (HMs) removal from contaminated water. The aim of this review was to critically analyze the status of research in HMs detection and adsorption, focusing on the adsorption approaches for better defining the corresponding future challenges and their potential solutions. Present research demonstrates the promising outlook for using remote sensing technology in the preliminary selection of contaminated areas before final HMs detection using spectrometry, microwave or electrochemical sensors. Adsorption can then be applied in treating HMs contaminated water due to its high effectiveness and low-cost. Natural zeolites showed 90 %-100 % Pb2+, 2 + , 95 % Cd2+ 2 + and 100 % Cu2+ 2 + removal from water, their effectiveness is affected by initial pH, and adsorbent dosage and size. As synthesized zeolites, zeolitized pumice waste showed 100-500 mg/g of HMs adsorption at pH 4.0-5.0, 57 mg/g Zn2+ 2 + by oxalate-loaded zeolites and 682 mg/g Pb2+ 2 + and 122 mg/g Ni2+ 2 + by zeolite nanoparticle impregnated polysulfone membrane from wastewater. Activated carbon exhibited 99 %-100 % Hg2+, 2 + , 93 % Cu2+ 2 + and 99 % Co2+ 2 + removal from water under acidic environment. Biochar is more ecofriendly and demonstrated its effectiveness in removing up to 98 % Cd2+, 2 + , 97 % Cu2+, 2 + , 99 % Pb and 94 % Zn2+ 2 + from water. Chitosan showed 755 mg/g Pb2+, 2 + , 979 mg/g Cd2+ 2 + and 877 mg/g Cu2+ 2 + removal at pH 2.0-6.0 from wastewater. Peat moss exhibited 96 % Cu2+ 2 + and 50 % Cr6+ 6 + removal from wastewater at lower pH. Similarly, bioremoval showed 143 mg/g Zn2+ 2 + (algae) adsorption at pH 6.0 in, and 90 % Cr6+ 6 + and 98 % Cu2+ 2 + removal by biomass ash. Recently, carbon, magnetic and titanium nanotubes/composites have shown high efficiency and selectivity in HMs removal, but their preparation is often more expensive than their counterparts. In addition, adding enhancement solutions promoted HMs adsorption and reduced treatment time. Chemical precipitation demonstrated feasibility to recycle and recover extracted HMs and spent adsorbent. This review demonstrates the need for highly selective and efficient adsorbent, and guides the future researchers to make funtionalized and organic-inorganic composite HMs adsorbents.

Use of Hydrous Manganese Dioxide As a Potential Sorbent for Selective Removal of Lead, Cadmium, and Zinc Ions from Water.

Selective Adsorption of Cd(II) and Zn(II) Ions by Nano-Hydrous Manganese Dioxide (HMO)-Encapsulated Cation Exchanger

Fabrication of polymer-supported nanosized hydrous manganese dioxide (HMO) for enhanced lead removal from waters.

Selective Capture of Thallium(i) Ion from Aqueous Solutions by Amorphous Hydrous Manganese Dioxide

An Efficient Approach for Pb(Ii) and Cd(Ii) Removal Using Manganese Dioxide Formed in Situ

Efficient Removal of Pb(II) with Manganese Oxide Modified from Low Grade Pyrolusite

Poly(diallyldimethylammonium-MoS4) Based Amorphous Molybdenum Sulphide Composite for Selectively Mercury Uptake from Wastewater Across a Large Ph Region.

Manganese-doped hydroxyapatite as an effective adsorbent for the removal of Pb(II) and Cd(II)

Highly efficient removal of heavy metals by polymer-supported nanosized hydrated Fe(III) oxides: behavior and XPS study.

Hydrous manganese dioxide modified poly(sodium acrylate) hydrogel composite as a novel adsorbent for enhanced removal of tetracycline and lead from water

Highly efficient removal of bivalent heavy metals from aqueous systems by magnetic porous Fe3O4-MnO2: Adsorption behavior and process study

Adsorption of Heavy Metal Ions on Two Types of Manganese Oxides Analyzed by Aas and Afs

Efficient, Stable and Selective Adsorption of Heavy Metals by Thio-Functionalized Layered Double Hydroxide in Diverse Types of Water

Simultaneous and Efficient Removal of Multiple Heavy Metal(loid)s from Aqueous Solutions Using Fe/Mn (hydr)oxide and Phosphate Mineral Composites Synthesized by Regulating the Proportion of Fe(II), Fe(III), Mn(II) and PO43.

Efficient Removal of Hg(II) by Polymer-Supported Hydrated Metal Oxides from Aqueous Solution

Efficient removal of heavy metal ions from wastewater and fixation of heavy metals in soil by manganese dioxide nanosorbents with tailored hollow mesoporous structure

Fe-MoS4: an Effective and Stable LDH-Based Adsorbent for Selective Removal of Heavy Metals

Heavy Metals Detection and Removal from Contaminated Water: A Critical Review of Adsorption Methods

[Preparation of Nanocomposite Hydrogel and Its Adsorption of Heavy Metal Ions].

Amorphous molybdenum sulfide mediated EDTA with multiple active sites to boost heavy metal ions removal

Highly Efficient and Selective Hg(II) Removal from Water by Thiol-Functionalized MOF-808: Kinetic and Mechanism Study