Abstract:Gas-Projectile-Assisted Injection Molding (G-PAIM) is a new injection molding process derived from the Gas-Assisted Injection Molding (GAIM) process by introducing a projectile to it. In this study, the short-shot method and the overflow method of both the G-PAIM and GAIM processes were experimentally compared and investigated in terms of the wall thickness of the pipes and its uniformity. The results showed that the wall thickness of the G-PAIM molded pipe was thinner and more uniform than that of the GAIM molded pipe, and the wall thickness of the pipe molded by the Gas-Projectile-Assisted Injection Molding Overflow (G-PAIM-O) process was the most uniform. For the G-PAIM-O process, the influence of processing parameters, including melt temperature, gas injection delay time, gas injection pressure, melt injection pressure and mold temperature, on the wall thickness and uniformity of the G-PAIM-O pipes were studied via the single-factor experimental method. It was found that the effects of gas injection delay time and gas injection pressure on the wall thickness of the G-PAIM-O pipes were relatively significant. The wall thickness of the pipes increased with the increase in gas injection delay time and decreased with the increase in gas injection pressure. The melt temperature, melt injection pressure and mold temperature had little effect on the wall thickness of the G-PAIM-O pipes. In general, the wall thickness uniformity of the G-PAIM-O pipes was slightly affected by these processing parameters.

EXPERIMENTAL INVESTIGATION ON GAS-ASSISTED CO-INJECTION MOLDING PROCESS

Soft Computing Applied to Gas-Assisted Injection Molding Process Optimization

Optimization of the gas-assisted injection moulding process using multiple gas-injection systems

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Effect of gas on the polymer temperature in external gas-assisted injection molding

Study on Computer Simulation of Co-injection Molding

Factors Affecting the Stability of Gas Penetration in Gas Assist Injection Molded Bifurcation Parts

Influence of gas counter pressure injection molding parameters on shrinkage ratio of plastic part

Research on the Gas-assisted Injection Molding of the Box Shape Plastic Parts Based on 2.5D Numerical Simulation

Mechanism and Application on Steam Injection Technology

Influence of Gas Inlet Slit Width on Gas-Assisted Plastic Micro-Tube Extrusion

Research on the Application of Injection Molding Simulation Technology in Mold Design

New Injection Molding Technology and Development for Polymer Materials

Optimize Injection-Molding Process Parameters and Build an Adaptive Process Control System Based on Nozzle Pressure Profile and Clamping Force

Effective fast-response pressure control for thin-wall gas-assisted injection molding

Recent Advances on Fluid Assisted Injection Molding Technique

Visual Computer-based Simulation of Sandwich Injection Molding Process:Influence of Shape of Rectangle Goods and Injection Gate Location on Breakthrough Phenomenon of Core Melt

Numerical and Experimental Studies on the Improvement of Gas Chamber Structure During Gas-Assisted Extrusion

Effects of Processing Method and Parameters on the Wall Thickness of Gas-Projectile-Assisted Injection Molding Pipes

Intelligent Injection Molding on Sensing, Optimization, and Control