Abstract:The application of calibration transfer methods has been successful in combination with near-infrared spectroscopy or other tools for prediction of chemical composition. One of the developed methods that can provide accurate performances is the piecewise direct standardization (PDS) method, which in this paper is firstly applied to transfer from one day to another the second-order calibration model based on alternating trilinear decomposition (ATLD) method built for the interference-free resolution and determination of multi-analytes in complex systems by liquid chromatography-mass spectrometry (LC-MS) in full scan mode. This is an example of LC-MS analysis in which interferences have been found, making necessary the use of second-order calibration because of its capacity for modeling this phenomenon, which implies analytes of interest can be resolved and quantified even in the presence of overlapped peaks and unknown interferences. Once the second-order calibration model based on ATLD method was built, the calibration transfer was conducted to compensate for the signal instability of LC-MS instrument over time. This allows one to reduce the volume of the heavy works for complete recalibration which is necessary for later accurate determinations. The root-mean-square error of prediction (RMSEP) and average recovery were used to evaluate the performances of the proposed strategy. Results showed that the number of calibration samples used on the real LC-MS data was reduced by using the PDS method from 11 to 3 while producing comparable RMSEP values and recovery values that were statistically the same (F-test, 95% confidence level) to those obtained with 11 calibration samples. This methodology is in accordance with the highly recommended green analytical chemistry principles, since it can reduce the experimental efforts and cost with regard to the use of a new calibration model built in modified conditions.

Expansion of Dynamic Working Range and Correction for Interferences in Flame Atomic-Absorption Spectrometry Using Flow-Injection Gradient Ratio Calibration with A Single Standard

Expansion of Dynamic Range of Flame Atomic Absorption Spectrometry by an Efficient Flow Injection Dilution System Based on Dispersion of Microliter-Volume Samples

A New Flow Injection Single-Standard Calibration Method for Flame Atomic Absorption Spectrometry Based on Dilution by Microsample Dispersion

Optimisation of Experimental Parameters for Flow Injection Flame Atomic Absorption Spectrometry

Compensation of Calibration Graph Curvature and Interference in Flow-Injection Spectrophotometry Using Gradient Ratio Calibration

Contribution of System Components to Dispersion in the Analysis of Microvolume Samples by Flow-Injection Flame Atomic-Absorption Spectrometry

Flow Injection Atomic Absorption Spectrometry

Flow injection on-line dilution for flame atomic absorption spectrometry by micro-sample introduction and dispersion using syringe pumps

An Efficient Flow-Injection Online Dilution System for Flame Atomic-Absorption Spectrometry Based on Micro-Zone Penetration

A Microsampling System for Flame Atomic Absorption Spectrometry Using Hydrodynamic Injection

A New Flow Injection Calibration System Based On Automatic Diagnosis And Correction For Fault Peak Signal Using Flow Injection Gradient Information

High Efficiency Low Sample Consumption On-Line Ion-Exchange Pre-Concentration System for Flow Injection Flame Atomic Absorption Spectrometry

Critical Evaluation of the Efficiency and Synergistic Effects of Flow Injection Techniques for Sensitivity Enhancement in Flame Atomic Absorption Spectrometry

Analysis of Samples with High Dissolved Solids Content Using Flow-Injection Flame Atomic-Absorption Spectrometry

Combination of Flow-Injection Techniques with Atomic Spectrometry in Agricultural and Environmental Analysis

Solving Signal Instability to Maintain the Second-Order Advantage in the Resolution and Determination of Multi-Analytes in Complex Systems by Modeling Liquid Chromatography–mass Spectrometry Data Using Alternating Trilinear Decomposition Method Assisted with Piecewise Direct Standardization

Studies On Gas Concentration Reconstruction Methods For Simultaneous Temperature And H2o Concentration Tomographic Imaging In A Flame Based On Tunable Diode Laser Absorption Spectroscopy

Adaptive handling of Rayleigh and Raman scatter of fluorescence data based on evaluation of the degree of spectral overlap

Simultaneous Flame Photometric-Determination of Lithium, Sodium, Potassium, and Calcium by Flow-Injection Analysis with Gradient Scanning Standard Addition

New Developments in Flow Injection Vapor Generation Atomic Absorption Spectrometry

Stack Emission Monitoring Using Non-Dispersive Infrared Spectroscopy with an Optimized Nonlinear Absorption Cross Interference Correction Algorithm