Abstract:Acceleration measurement plays an important role in a variety of fields in science and engineering. In particular, the accurate, continuous and non-contact recording of the shock acceleration profiles of the free target surfaces is considered as a critical technique in shock physics. Various kinds of optical interferometers have been developed to monitor the motion of the surfaces of shocked targets since the 1960s, for instance, the velocity interferometer system for any reflector, the fiber optic accelerometer, the photonic Doppler velocimetry system and the displacement interferometer. However, most of such systems rely on the coherent quasi-monochromatic illumination and discrete optic elements, which are costly in setting-up and maintenance. In 1996, L. Levin et al reported an interferometric fiber-optic Doppler velocimeter with high-dynamic range, in which fiber-coupled components were used to replace the discrete optic elements. However, the fringe visibility of the Levin's system is low because of the coupled components, which greatly limits the reliability and accuracy in the shock measurement. In this paper, a compact all-fiber interferometer system for measuring the shock acceleration is developed and tested. The advantage of the system is that not only removes the non-interfering light and enhances the fringe visibility, but also reduces polarization induced signal fading and the polarization induced phase shift. Moreover, it also does not require a source of long coherence length. The system bases entirely on single-mode fiber optics and mainly consists of a polarization beam splitter, a faraday rotator, a depolarizer and a 3x3 single-mode fiber coupler which work at 1310 nm wavelength. The optical systems of the interferometer are described and the experimental results compared with a shock acceleration calibration system with a pneumatic exciter (PneuShock(TM) Model 9525C by The Modal Shop) are reported. In the shock acceleration test, the interferometer system measured shock acceleration with peak accelerations of similar to 100,000 m/s(2) and the durations of similar to 0.2 ms which are conformed to the results of the shock acceleration calibration system. The measured relative error of the acceleration is within 3%.

A vibration measuring sensor of All- fiber interferometer

Study and Establishment of the National Standard of the Ultra-low frequency Vibration

Research on angular vibration measurement system based on heterodyne interference

Vibration Compensating Beam Scanning Interferometer for Surface Measurement

A High-Frequency Angular Vibration Calibration System Based on Phase Modulated Laser Interferometer Technique

Experimental study on a novel all-fiber vibration velocity interferometer

Micro-vibration measuring technology based on heterodyne interference

Vibration Measurement of Smart Composite Structures by Using the New Intensity Modulated Optical Fiber Sensor

Distributed Single Fiber Optic Vibration Sensing with High Frequency Response and Multi-Points Accurate Location

Compact All-Fiber Interferometer System for Shock Acceleration Measurement

Development of A Distributed Fiber Sensor for Simultaneous Strain and Vibration Measurement

The Application of Wide Spectrum Laser in Noncontact Vibration Measurement

Design and analysis of high-frequency fiber Bragg grating vibration sensor

All-Fiber Velocity Interferometer for Multipoint Measurement

A New Type of Dynamic Vibration Fiber Sensor

Acoustic Vibration Sensor Based on Nonadiabatic Tapered Fibers

Low-Frequency Vibration Sensor with Dual-Fiber Fabry–Perot Interferometer Using a Low-Coherence LED

Optical Fiber Low-Frequency Vibration Sensor Based on Butterfly-Shape Mach-Zehnder Interferometer

Research on optical fiber dual-interferometry for on-line and absolute measurement

A Novel All-Fiber Velocity Measurement System with High Fringe Contrast

Interferometer-Based Distributed Optical Fiber Sensors in Long-Distance Vibration Detection: A Review