Abstract:Acceleration measurement plays an important role in a variety of fields in science and engineering. In particular, the accurate, continuous and non-contact recording of the shock acceleration profiles of the free target surfaces is considered as a critical technique in shock physics. Various kinds of optical interferometers have been developed to monitor the motion of the surfaces of shocked targets since the 1960s, for instance, the velocity interferometer system for any reflector, the fiber optic accelerometer, the photonic Doppler velocimetry system and the displacement interferometer. However, most of such systems rely on the coherent quasi-monochromatic illumination and discrete optic elements, which are costly in setting-up and maintenance. In 1996, L. Levin et al reported an interferometric fiber-optic Doppler velocimeter with high-dynamic range, in which fiber-coupled components were used to replace the discrete optic elements. However, the fringe visibility of the Levin's system is low because of the coupled components, which greatly limits the reliability and accuracy in the shock measurement. In this paper, a compact all-fiber interferometer system for measuring the shock acceleration is developed and tested. The advantage of the system is that not only removes the non-interfering light and enhances the fringe visibility, but also reduces polarization induced signal fading and the polarization induced phase shift. Moreover, it also does not require a source of long coherence length. The system bases entirely on single-mode fiber optics and mainly consists of a polarization beam splitter, a faraday rotator, a depolarizer and a 3x3 single-mode fiber coupler which work at 1310 nm wavelength. The optical systems of the interferometer are described and the experimental results compared with a shock acceleration calibration system with a pneumatic exciter (PneuShock(TM) Model 9525C by The Modal Shop) are reported. In the shock acceleration test, the interferometer system measured shock acceleration with peak accelerations of similar to 100,000 m/s(2) and the durations of similar to 0.2 ms which are conformed to the results of the shock acceleration calibration system. The measured relative error of the acceleration is within 3%.

All-Fiber Velocity Interferometer for Multipoint Measurement

All-fiber multipoint VISAR

Method of Fiber Transfer Delay Measurement Based on Phase Quantization and Delay Synthesis

Experimental study on a novel all-fiber vibration velocity interferometer

A Novel All-Fiber Velocity Interferometer Based on Optic-Feedback Delay Line

All Fiber Optical Velocity Interferometer Research

A Novel All-Fiber Velocity Measurement System with High Fringe Contrast

All-Fiber Displacement Interference Velocity Measurement System Data Processing Method Research Based On S-Transformation

All-fiber Velocity Measurement System Based on Receiving Diffuse Reflection by Multiple Fibers

High-Precision Fiber-Optic Time Transfer System Based on Bidirectional FDM and Correlation Processing

All-Fiber Configuration Laser Self-Mixing Doppler Velocimeter Based on Distributed Feedback Fiber Laser

Single-mode fiber, velocity interferometry

Multichannel precision time delay measurement in optical fibers

A vibration measuring sensor of All- fiber interferometer

Compact All-Fiber Interferometer System for Shock Acceleration Measurement

Accurate and Fast Fiber Transfer Delay Measurement Based on Phase Discrimination and Frequency Measurement

Distributed Optical Fiber Sensing Measurement Based on Time Offset

All-fiber heterodyne velocity and displacement interferometer based on DPLL Doppler tracking with sub-nanometer per second and picometer sensitivity

Application of Fiber Optic Interferometer System in Flyer Plates Velocity Measuring

Universal Fiber-Optic Point Sensor System for Quasi-Static Absolute Measurements of Multiparameters Exploiting Low Coherence Interrogation