Abstract:The process of selective non-catalytic reduction of NO, SNCR, is important for limiting emissions of nitrogen oxides from coal-fired power plants. Such a process has been studied for many years, both in the laboratory and under practical conditions. This work was an attempt at elucidating some of the problems associated with the method when used under circulating fluidized bed (CFB) conditions and in particular, the formation of the N2O by-product. The NO+NH3 reaction has been studied in the laboratory, over quartz sand in a heated fixed bed flow reactor. In comparison with a combustion environment, the composition of the gas phase was drastically simplified and limited to NO and NH3, in nitrogen as the carrier gas, with O2 added in some experiments. The product gases were analyzed for NO, N2O and NH3. The effects the following parameters were studied: temperature inside the reactor between 850 and 1250K, height of the sand bed, NH3/NO molar ratio over the range 0.54–2.0 and the addition of 1 or 2% of O2 in volume. Baseline tests with an empty reactor were also made. With no sand in the reactor, the results were both qualitatively and quantitatively different. The sand helped to increase the efficiency of NO reduction, particularly at lower temperatures, but N2O formation also appeared to be strongly enhanced, except at the highest temperatures. Higher molar NH3/NO ratios favored NO reduction and N2O production, both with and without sand. The reduction of NO did not appear to require the presence of O2, but the introduction of 1% or 2% of O2 gave some benefit. The results confirmed that under practical conditions more attention should be paid to the role of the bed solids in the SNCR process.

NH_3 Oxidation Using SNCR to Control Cement Kiln NO_x

@Experimental Study of the Influence of CaCO3on NH3+NO+O2 Reaction System

Tailoring the Proceeding of the NH3-SCO and NH3-SCR Reactions over FeOx Catalysts by Modifying with NbOx

Study on the Catalysis of CaCO3 in the SNCR Denox Process for Cement Kilns

Study On The Influence Of Cao On Nh3+No+O-2 Reaction System In Pre-Calciner

Influence of CaCO_3 on NH_3 Oxidation

Influence of Calcium-Based Particles on the Selective Non-Catalytic Reduction Process in a Pre-Calciner

Mechanism Study on the Adsorption and Reactions of NH3, NO, and O2 on the CaO Surface in the SNCR Denox Process

Effect of CaO on the selective non-catalytic reduction deNO x process: Experimental and kinetic study

In Situ DRIFTS Studies of NH3-SCR Mechanism over V2O5-CeO2/TiO2-ZrO2 Catalysts for Selective Catalytic Reduction of NOx

Experimental Study of Selective Non-catalytic Reduction of NO by NH_3

The Formation of N2O During the Reduction of NO by NH3

Selective Non-Catalytic Reduction of Nox in the Flue Gas by Ammonium Bicarbonate Solution

CeO2 Nanoparticle-Loaded MnO2 Nanoflowers for Selective Catalytic Reduction of NOx with NH3 at Low Temperatures

Calculation And Analysis Of Influence Of Coal Gas On Selective Non-Catalytic Reduction Of Nitric Oxide By Ammonia

Selective Catalytic Reduction of No with Nh3 over Mnox-Ceo2-Wo3-Zro2: Effect of Calcination Temperature

Experimental Study of the Influences of Additives on Selective Non-catalytic Reduction Process and Ammonia Oxidation

Low-Temperature Reduction of NOx by NH3 with Unity Conversion on Nanofilament MnO2/Activated Semi-Coke Catalyst

Selective catalytic reduction of NOx with NH3 by monolithic catalyst MnOx/AC/C under low temperature in the presence of excess O2

Selective Catalytic Reduction of NO<sub>X</sub> on Cr-Mn Mixed Oxide at Low Temperature

Novel Mnox Catalyst for Low-Temperature Selective Catalytic Reduction of Nox with Nh3