Abstract:This work presents a hydrothermal-based facile method for synthesizing ZnFe 2 O 4, whose size can be controlled with the concentration of sodium acetate used as a fuel and its physical changes at nanoscales when exposed to two different gases. The structural, morphological, compositional, and electronic properties of the synthesized samples are also presented in this paper. The crystal structure of the synthesized samples was determined using an X-ray Diffractometer (XRD). The results revealed fluctuations in the size, lattice parameter, and strain in the nanoparticles with increasing the concentration of sodium acetate. Field-Emission Scanning Electron Microscopy (FESEM) was used to determine synthesized materials' morphology and particle size. It revealed that the particles possessed approximately spherical morphology whose size decreased significantly with the increasing amount of sodium acetate. Transmission Electron Microscopy (TEM) was utilized to determine the structure, morphology, and elemental distributions in particles at the nanoscale, and it confirmed the findings of XRD and FESEM analyses. The high-resolution TEM (HRTEM) imaging analysis of the nanoparticles in our studied samples revealed that the particles predominantly possessed (001) type facets. X-ray photoelectron spectroscopy (XPS) and core-loss electron energy loss spectroscopy (EELS) showed an increasing fraction of Fe 2+ with the decreasing size of the particles in samples. The Brunauer, Emmett, and Tellers (BET) analysis of samples revealed a higher surface area as the particle size decreases. In addition, the determined surface area and pore size values are compared with the literature, and it was found that the synthesized materials are promising for gas-sensing applications. The ab initio calculations of the Density of States (DOS) and Band structure of (001) surface terminating ZnFe 2 O 4 were carried out using Quantum Espresso software to determine the bandgap of the synthesized samples. They were compared to their corresponding experimentally determined bandgap values and showed close agreement. Finally, in-situ TEM measurement was carried out on one of the four studied samples with robust properties using Ar and CO 2 as reference and target gases, respectively. It is concluded from the presented study that the size reduction of the ZnFe 2 O 4 nanoparticles (NPs) tunes the bandgap and provides more active sites due to a higher concentration of oxygen vacancies. The in-situ TEM showed us a nanoscale observation of the change in one of the crystal structure parameters. The d spacing of ZnFe 2 O 4 NPs showed a noticeable fluctuation, reaching more than 5% upon exposure to CO 2 and Ar gases.

Correlation of Gas Sensitive Properties with Fe2O3-SnO2 Ceramic Microstructure Prepared by High Energy Ball Milling

Gas-sensitive Properties and Structure of Nanostructured ( - Materials Prepared by Mechanical Alloying

Characterization of Nanostructured Alpha-Fe2o3-Sno2 Solid Solutions Prepared by High Energy Ball Milling

Microstructure and gas sensitive properties of α(M: Sn and Ti) materials prepared by ball milling

High Ethanol Sensitive SnO2 Microspheres

Gas Sensing Property and Microstructure of SnO2 Nanocrystalline Prepared by Solid State Reaction—thermal Oxidation

Preparation of gas sensors by hollow SnO 2 electrospun nanofibers

Micro-spherical ZnSnO 3 Material Prepared by Microwave-Assisted Method and Its Ethanol Sensing Properties

Microstructural Evolution During High Energy Ball Milling of Fe2o3-Sio2 Powders

Synthesis and Gas Sensitivities of SnO2 Nanorods and Hollow Microspheres

Electrospinning Route for Α-Fe2o3 Ceramic Nanofibers and Their Gas Sensing Properties

Preparation and Gas Sensitivity Properties of ZnFe2O4 Semiconductors

The Microwave-Assisted Synthesis and Gas Sensing Properties for Ethanol of SnO2 Nanomaterials

Preparation and sensitive characteristics of nano ZnFe2O4 gas sensitive materials

High sensitivity and surface mechanism of MOFs-derived metal oxide Co3O4-SnO2 hollow spheres to ethanol

A Mössbauer Study of Iron/polytetrafluoroethylene Nanocomposites Prepared by High-Energy Ball Milling

Formation of 25 Mol% Fe2o3-Al2o3 Solid Solution by High-Energy Ball Milling

Enhanced Sensing Properties of SnO2 Nanofibers with a Novel Structure by Carbonization

Study the properties of Ball-Milled Vanadium Oxide Powders for Gas Sensor Applications

Improvement of gas sensitivity to ethanol by hydrothermal preparation of Dy-doped In2O3

Synthesis, characterization, and preliminary insights of ZnFe2O4 nanoparticles into potential applications, with a focus on gas sensing