Abstract:Molecular dynamics has been employed in this paper to investigate the nanoscale cutting process of single-crystal copper with a diamond tool. The behavior of the workpiece during material removal by diamond cutting has been studied. The effects of tool geometry including rake angle, clearance angle, and edge radius are thoroughly investigated in terms of chips, dislocation movement, temperature distribution, cutting temperature, cutting force, and friction coefficient. The investigation showed that an appropriate positive rake angle ([Formula: see text]), a suitable clearance angle ([Formula: see text]), or a smaller edge radius tip resulted in a smaller cutting force and a better subsurface finish. It was found that a tool with a rake angle of [Formula: see text] generated more chips, had a higher cutting efficiency, and produced a lower temperature in the workpiece, but a smaller rake angle tip was more conducive to protecting the groove compared to a large rake angle tip. Compared with a tool with a small clearance angle, the tool with a larger clearance angle generated more chips and caused a lower temperature rise in the copper workpiece, and prolonged its lifetime. In addition, a larger clearance angle tip was more conducive to protecting the groove. A smaller edge radius tip reduces the cutting heat during the nanoscale cutting process, while the volume of chips decreases. These results indicated that it is possible to control and adjust the tool parameters according to the tool rake angle, clearance angle, and edge radius during the machining of single-crystal copper, and a set of tool parameters were obtained: [Formula: see text] rake angle, [Formula: see text] clearance angle, and 0 nm edge radius which could reduce surface damage and the required cutting force.

Research on Nano-Cutting Processes Based on Parallel Molecular Dynamics

Controllable Diamond Cutting of Structured Surfaces with Subnanometric Height Features on Silicon

Analysis about Diamond Tool Wear in Nano-Metric Cutting of Single Crystal Silicon Using Molecular Dynamics Method

The Effect of Tool Geometry on Subsurface Damage and Material Removal in Nanometric Cutting Single-Crystal Silicon by A Molecular Dynamics Simulation

Research on Mechanism of Nanoscale Cutting with Arc Trajectory for Monocrystalline Silicon Based on Molecular Dynamics Simulation

Effect of tool rake angle on the material removal mechanism transition of single-crystal silicon: a molecular dynamics study

Nano-Vibration Cutting Process of Single Crystal Silicon by Molecular Dynamics

Influence of Geometry in Nanometric Cutting Single-Crystal Copper Via Md Simulation

Materials Removal Mechanism for Ultra-Precise Cutting of Single-Crystal Silicon with Natural Single-Crystal Diamond Tools by Experiment and Atomic Simulation

Molecular Dynamics Simulation of Nanometric Machining

Influence of laser nanostructured diamond tools on the cutting behavior of silicon by molecular dynamics simulation

Simulation Study of Cutting Forces, Stresses and Temperature During Nanometric Cutting of Single Crystal Silicon

MD Simulation of Effect of Crystal Orientation and Cutting Direction on Nanometric Cutting Using AFM Pin Tool

Investigation of Tool Geometry in Nanoscale Cutting Single-Crystal Copper by Molecular Dynamics Simulation

Analysis of the Influence of Tool Radius on Single Crystal Silicon Cutting Process Based on Molecular Dynamics

Influence of crystallographic effect on tool wear, cutting stress, cutting temperature, cutting force and subsurface damage in nano cutting of single crystal silicon carbide

Molecular Dynamics Simulation to Investigate the Rake Angle Effects on Nanometric Cutting of Single Crystal Ni3Al

Analysis of the Influence of Tool Radius on Mechanical State of Monocrystalline Silicon During Nano-Cutting

Molecular Dynamics Simulation of Elliptical Vibration Cutting

Molecular Dynamics Simulation on the Mechanism of Nanometric Machining of Single-Crystal Silicon

Effect of Tool Geometry in Nanometric Cutting of Nanotwinned Cu: a Molecular Dynamics Study