Abstract:The increasing demand for designing and manufacturing micro parts with high quality comes from the high speed development of micro electromechanical systems (MEMS) and nano electromechanical systems (NEMS) in recent years. Nanometric cutting as an important machining way of micro parts has become a hot spot in machining field. Some main issues in nanometric cutting such as chip formation, machined surface quantity and diamond tool wear etc., have been investigated by molecular dynamics. Previous researchers have pointed out that, the generation and evolution of defects are mainly, responsible for causing plastic deformation of machined workpiece in nanometric cutting of plastic materials and a high compressive stress remaining in shear zone is considered beneficial to ductile-mode machining of brittle materials. Up to now, however, the influence of cutting thickness on defect behaviors and stress distribution in a workpiece and the relationship between them for single crystal materials are still unclear. In the present study, molecular dynamics simulations of nanometric cutting of single crystal Cu were performed. The simulation results show that stacking fault and partial dislocation are two main types of the defects in workpieces. A high surface stress at the atomic scale was observed in workpieces and there exist the compressive stress in shear zones and tensile stresses in the machined surfaces. It is found that the stress-distance curves of workpieces present a clear periodicity corresponding to the generation and evolution of dislocations in them. At the beginning of cutting (a small cutting thickness), no apparent stacking faults inside workpieces have been found, but with the increase of cutting thickness, the defects on surfaces and subsurfaces increase significantly and the thicker the cutting thickness, the smaller the corresponding stress components.

Effect of Tool Geometry in Nanometric Cutting of Nanotwinned Cu: a Molecular Dynamics Study

Twin-size Effects on the Hardness and Plastic Deformation Mechanisms of Nanotwinned Diamond

Two softening stages in nanotwinned Cu

0701 Molecular Dynamics Simulation of Nano-Contact Between a Diamond Cutting Tool and a Copper Surface

Molecular dynamics simulations of nanomachining mechanism and thermal effects of single crystal Cu

Quasicontinuum Analysis of the Effect of Tool Geometry on Nanometric Cutting of Single Crystal Copper

The interaction between grain boundary and tool geometry in nanocutting of a bi-crystal copper

Study on the atomic removal behavior and damage formation mechanism of nano cutting copper-nickel alloy with diamond tool

Research on Nano-Cutting Processes Based on Parallel Molecular Dynamics

MD Simulation of Effect of Crystal Orientation and Cutting Direction on Nanometric Cutting Using AFM Pin Tool

Deformation Mechanism of Diamond Nanocutting Single-Crystal Copper Using Molecular Dynamics Simulatio

Molecular Dynamics Simulation to Investigate the Rake Angle Effects on Nanometric Cutting of Single Crystal Ni3Al

MOLECULAR DYNAMICS SIMULATION OF NANOMETRIC CUTTING CHARACTERISTICS OF SINGLE CRYSTAL Cu

Nanometric Cutting of Copper: A Molecular Dynamics Study

Molecular Dynamics Simulations of Thermal Effects in Nanometric Cutting Process

MOLECULAR DYNAMICS SIMULATIONS OF NANOMA-CHINING MECHANISM AND THERMAL EFFECTS OF SINGLE CRYSTAL Cu

Large Scale Molecular Dynamics Study of Nanometric Machining of Copper

Atomistic Investigation of Probe-Based Nanomachining on Cu Twin Boundaries

Effects of tool geometry on tungsten removal behavior during nano-cutting

Molecular Dynamics Simulation of Subsurface Deformed Layers in Afm-Based Nanometric Cutting Process

Study of Materials Deformation in Nanometric Cutting by Large-scale Molecular Dynamics Simulations