Abstract:We propose a practical general method, called the linear time-over-threshold (linear TOT) scheme, for nuclear pulse amplitude digitization aiming at providing a high degree of integration for a high-channel count detector system. The most critical technique in the scheme is that for a different particle detector and diverse pulse shaping, how to produce the time-varying dynamic threshold voltage, which enables the linear conversion from the peak amplitude of nuclear pulse to the TOT time width. Compared with the normal time-over-threshold method for pulse height digitizing, the linear TOT has a strict linearity, large measurable signal dynamic range, and good signal-to-noise ratio. Using the scheme, we design a prototype of a field-programmable gate-array (FPGA)-based 64-channel data-acquisition (DAQ) system for a continuous crystal poistron emission tomography detector. The system only consists of 64-channel active RC integrators and voltage comparators, a shared dynamic threshold generating circuit, and an FPGA. The physical size of the system is so small that it could be attached on the base of the PMT. The preliminary test results show that the nonlinearity between pulse amplitude and TOT time width is about 0.01%, and the prototype could achieve an energy resolution of 12.3% by 22Na coincident spectrum measurement, which is better than the result (14.6%) obtained using our previous homemade DAQ system designed with a normal analog-to-digital converter technique. The design proves that the linear TOT scheme is an effective solution for a high-channel count digitizing system in nuclear detection, not only for its high performance, but also for a high degree of integration.

Effective dynamic range in measurements with flash analog-to-digital convertor

A Sub-1μW 16-Bit Fully Dynamic Zoom ADC Compatible with Free-running and Incremental Modes Using Residue Feedforward and Extended Counting Techniques

A Flash Window ADC for DVS-enabled Digital Controlled DC-DC Converters

A Linear Time-Over-Threshold Digitizing Scheme and Its 64-Channel Daq Prototype Design on Fpga for A Continuous Crystal Pet Detector

A Highly Linear FPGA-Based TDC and a Low-Power Multichannel Readout ASIC with a Shared SAR ADC for SiPM Detectors

An FPGA-based 64-channel DAQ system using linear time-over-threshold scheme for a continuous crystal PET detector

An FPGA-Based 64-Channel Readout Electronics for High-Resolution TOF-PET Detectors

A Digital-Assistant Time-To-Amplitude Converter With Dynamic Range Improvement

A 100ms/s 5bit Fully Digital Flash ADC with Standard Cells.

High Dynamic Range X-ray Detector Pixel Architectures Utilizing Charge Removal

Study on FPGA-based multi-channel digitizing method for nuclear pulse amplitude

A Novel Nuclear Pulse Digitizing Scheme Using Time over Dynamic Threshold

A Large Dynamic Range Readout Design for the Plastic Scintillator Detector of DAMPE

Performance Optimization of Pixelated CdZnTe Detector Readout by Analog ASIC Using Cathode Waveform

A Flash ADC with Low Offset Dynamic Comparators

HDR CCD Image Sensor System Through Double-A/D Convertors

An FPGA Based Fast Linear Discharge Method for Nuclear Pulse Digitization

500 MS/s 4-Bit Flash ADC with Complementary Architecture

Design and simulation of a 12-bit, 40 MSPS asynchronous SAR ADC for the readout of PMT signal

A Fully Integrated 10-Bit 100 MS/s SAR ADC with Metastability Elimination for the High Energy Physics Experiments

A 44μw 140Db-Dr Hybrid Light-to-Digital Converter with Current-Tracking Dynamic Zoom and Power-Scaling OTA