Abstract:Electrospinning is a simple and straightforward process by which continuous polymer fibers with diameter ranging from a few nanometers to microns can be produced using an electrostatically driven jet of polymer solution(or polymer melt).In the present contribution,ultrafine fibers were spun from polyethylene oxide(PEO)/water solution using a homemade electrospinning set-up.The effects of the concentration of polymer solution and spinning voltage on the morphology of fibers and distribution of fiber diameters were investigated.A more comprehensive and systematic understanding of process parameters of the electrospinning was obtained.In this experiment fibers with diameter ranging from 100 nm to 1000 nm were obtained.The results showed that both the concentration of polymer solution and spinning voltage were important factors characterizing the morphology of fibers and distribution of fiber diameters.The concentration of polymer solution played an important role in the morphology of the fibers obtained.Lower concentration of polymer solution(0.04 kg/L PEO aqueous solution) tended to facilitate the formation of fibers with beads,and smooth and uniform fibers without beads were obtained at the concentration of 0.05 kg/L PEO aqueous solution and 0.06 kg/L PEO aqueous solution.As other process parameters were fixed,raising the concentration of polymer solution resulted in the increasing of average diameter of fibers.Spinning voltage also had an influence on the average diameter of fibers.Thinner fibers were received on the target with higher voltage applied on the nozzle at a given flow rate.The morphology of fibers electrospun from PEO was observed and analyzed by scanning electron microscopy(SEM).

Study on electrospinnability of PVP/PEO composite micro-nano fibers

Experimental Investigation of the Effect of Processing Parameters on the Formation of Electrospun Polyethylene Oxide Nanofibers

Study on the Effect of Poly(ethylene Oxide)on the Electrospinning of Soy Protein Isolate

Preparation and Properties of Poly (vinyl Alcohol) Nanofibers by Electrospinning

Optimization of Electrospinning Parameters for Lower Molecular Weight Polymers: A Case Study on Polyvinylpyrrolidone

Effect of hyperbranched poly(ester amine) additive on electrospinning of low concentration poly(methyl methacrylate) solutions

Preparation of PVP/PLLA Ultrafine Blend Fibers by Electrospinning

Morphological Modulation of Electrospun PVDF/PVP Nanofibers

Evaluation of Electrospun Nanofiber Formation of Perfluorosulfonic Acid and Poly (N-Vinylpyrrolidone) Through Solution Rheology

IMPROVEMENT OF POLY(METHYL METHACRYLATE) ELECTROSPUN FIBER UNIFORMITY BY ADDITION OF POLY(ESTER AMINE)

Effect of PEO on the Hydrophilicity of PLLA Ultrafine Fibers

Effects of Solvent on Structures and Properties of Electrospun Poly(ethylene Oxide) Nanofibers

Study on the Electrospinnability of Polyvinyl Alcohol Solutions by Using Water/N, N-dimethylacetamide or Water/N, N-dimethylformamide As Solvents

Synthesis of Hollow PVP/Ag Nanoparticle Composite Fibers via Electrospinning under a Dense CO2 Environment

Electrospinning of Soy Protein Isolate/Poly (vinyl alcohol)

Optimization design and properties of PVA/GEL nanofibers

Preparation and Properties of Electrospun Soy Protein Isolate/Polyethylene Oxide Nanofiber Membranes

The preparation of polypropylene microfiber yarns via vortex airflow‐assisted melt differential electrospinning

Preparation and characterization of EPDM ultrafine fibers by electrospinning

Properties of Poly (ethylene oxide)/ whey Protein Isolate Nanofibers Prepared by Electrospinning

Electrospinning of ultrafine PVDF/PC fibers from their dispersed solutions