Abstract:Digital micro-controllers/processors enable the costeffective control of grid-connected power converter systems in terms of system monitoring, signal processing (e.g., grid synchronization), control (e.g., grid current and voltage control), etc. Normally, the control is implemented in a micro-controller/processor with a fixed sampling rate considering the cost and complexity, where the number of unit delays that have been adopted should be an integer. For instance, in conventional digital control systems, a single-phase T/4 Delay Phase-Locked Loop (PLL) system takes 50 unit delays (i.e., in a 50-Hz system with a sampling frequency of 10-kHz) to create a 90 degrees-lagging voltage in order to achieve the grid synchronization with the orthogonal voltage system. However, in practice, the grid frequency is a time-variant parameter due to various eventualities, and thus rounding the number of the unit delays for the T/4 Delay PLL system should be done in its implementation. This process will result in performance degradation in the digital control system, as the exactly required number of delays is not realized. Hence, in this paper, a Virtual Unit Delay (VUD) has been proposed to address such challenges to the digital T/4 Delay PLL system. The proposed VUD adopts linear interpolation polynomial to approximate the fractional delay induced by the varying grid frequency in such a way that the control performance is enhanced. The proposed VUD has been demonstrated on a digitally controlled T/4 Delay PLL system. Experimental results have confirmed the effectiveness of the proposal.

Design and Analysis of A Modified Digitally Controlled Programmable Delay Element

High Resolution Digital Pulse Width Modulation Design For Digital Dc-Dc Converter

Digitally Controllable Delay Element Using Switched-Current Mirror

Power Optimized Digitally Programmable Delay Element

A power efficient digitally programmable delay element for low power VLSI applications

An Active Circulator-Based Delay Line

A High‐resolution Hybrid Digital Pulse Width Modulator with Dual‐edge‐triggered Flip‐flops and Hardware Compensation

Virtual Unit Delay For Digital Frequency Adaptive T/4 Delay Phase-Locked Loop System

An 8-Bit 4Fs-Step Digitally Controlled Delay Element with Two Cascaded Delay Units

A low-power, area-efficient all-digital delay-locked loop for DDR3 SDRAM controller

A Novel Digital DLL and Its Implement on the FPGA.

A 2.5ghz Adpll With Pvt-Insensitive Delta Sigma Dithered Time-To-Digital Conversion By Utilizing An Addll

A 2.5GHz ADPLL with PVT-insensitive ΔΣ dithered time-to-digital conversion by utilizing an ADDLL.

A Novel Delay Manager Based on Digital DLL Used to Adjust the Delay Time of FPGA's IO Cell

A Multi-Channel Digital Programable Delay Trigger System with High Accuracy and Wide Range

A Digital DLL-Based Delay Management Circuit for FPGA's IO Cell

Delay Analysis of Combinational Circuit in Using Programmable Logic Device

Design and Analysis of a Robust All-Digital Clock Generation System with a DLL-based TDC

A Delay-Line DPWM Architecture With Compensation Module and Delay-Adjustable Unit Based on DLL

A New FPGA-Based Segmented Delay-Line DPWM with Compensation for Critical Path Delays

Design of A Delay-Locked-Loop-Based Time-To-Digital Converter