Abstract:The prospect of blending gasoline fuel with ethanol is being investigated as a potential way to improve the knock residence of the base gasoline. However, one of the drawbacks is a lack of proper understanding of the reason for the non-linear response of blending ethanol and gasoline. This non-linearity could be better understood by an improved knowledge of the interactions of these fuel components at a molecular level. This study proposed a highly reduced four-component (toluene/n-heptane/iso-octane/ethanol) gasoline surrogate model containing 59 species and 270 reactions. The model was reduced using the direct relation graph with expert knowledge (DRG-X) (Lu and Law, 20015; Lu et al., 2011) and isomer lumping method. The computational singular perturbation (CSP) analysis were performed to reduce the potential stiffness issues by accordingly adjusting the Arrhenius coefficients of the proper reactions. The model has been comprehensively validated against wide range of ignition delay times (IDT) and flame speed (FS) measurement data as well as compared against two representative literature models from Liu et al. (2013) and Wang et al. (2015). Overall, good agreements were observed between model predictions and experimental data across the entire research octane number (RON), equivalence ratio, pressure and temperature range. In addition, the model has also been coupled with the computational fluid dynamic (CFD) models to simulate the experimental data of constant volume reacting spray of a low-octane gasoline (Haltermann straight-run naphtha), and in-cylinder pressures and temperatures of a high-octane gasoline (Haltermann Gasoline) combustion in a heavy duty compression ignition engine. The coupled model can qualitatively predict the experimentally obtained data with an improved performance for PRF, TPRF, and TPRF-ethanol surrogates.

Nine Lumped Kinetic Models of FCC Gasoline under the Aromatization Reaction Conditions

Lumped Kinetics Model and Its On-Line Application to Commercial Catalytic Naphtha Reforming Process

Eight Lumps Kinetic Model for Residual Oil Catalytic Cracking

Kinetic model for hydroisomerization reaction of C<sub>8</sub>-aromatics

Kinetic Model for Hydroisomerization Reaction of C8-aromatics

An Introduction to the Lump Kinetics Model and Reaction Mechanism of Fcc Gasoline

Five Lumped Kinetic Models of Liquefied Petroleum Gas under Aromatization Reaction Conditions

Kinetic Model and Simulation Analysis for Toluene Disproportionation and C9-Aromatics Transalkylation

Kinetic Modeling of C2–C7 Olefins Interconversion over ZSM-5 Catalyst

Aromatization Reactions of Three Gasoline Fractions

The Aromatization Processing Function for FCC Gasoline and LPG

An Orthogonal Method for Aromatization Reactions of Shenghua Liquefied Petroleum Gas

STUDY ON EIGHT LUMPING DYNAMIC MODELS FOR FCC GASOLINE UPGRADING

Reaction Mechanism and Kinetic Modeling of Hydroisomerization and Hydroaromatization of Fluid Catalytic Cracking Naphtha

Effects of Reaction Temperature on Distribution of Aromatization Reaction Products of Liquefied Petroleum Gas

PRODUCT DISTRIBUTION AND REACTION KINETICS IN THE AROMATIZATION OF YANHUA FCC GASOLINE

Lumps and Kinetics for the Secondary Reactions in Catalytically Cracked Gasoline

A Study on the Aromatization Reaction of Lanlian FCC Gasoline

Coke Deactivation Kinetics for FCC Gasoline and C4 LPG

Development of a Reduced Four-Component (Toluene/n-Heptane/iso-octane/ethanol) Gasoline Surrogate Model

Studies on the Aromatization Reaction of Lpg and Gasoline: Reaction Behaviors and Mechanistic Pathways