Abstract:The prospect of blending gasoline fuel with ethanol is being investigated as a potential way to improve the knock residence of the base gasoline. However, one of the drawbacks is a lack of proper understanding of the reason for the non-linear response of blending ethanol and gasoline. This non-linearity could be better understood by an improved knowledge of the interactions of these fuel components at a molecular level. This study proposed a highly reduced four-component (toluene/n-heptane/iso-octane/ethanol) gasoline surrogate model containing 59 species and 270 reactions. The model was reduced using the direct relation graph with expert knowledge (DRG-X) (Lu and Law, 20015; Lu et al., 2011) and isomer lumping method. The computational singular perturbation (CSP) analysis were performed to reduce the potential stiffness issues by accordingly adjusting the Arrhenius coefficients of the proper reactions. The model has been comprehensively validated against wide range of ignition delay times (IDT) and flame speed (FS) measurement data as well as compared against two representative literature models from Liu et al. (2013) and Wang et al. (2015). Overall, good agreements were observed between model predictions and experimental data across the entire research octane number (RON), equivalence ratio, pressure and temperature range. In addition, the model has also been coupled with the computational fluid dynamic (CFD) models to simulate the experimental data of constant volume reacting spray of a low-octane gasoline (Haltermann straight-run naphtha), and in-cylinder pressures and temperatures of a high-octane gasoline (Haltermann Gasoline) combustion in a heavy duty compression ignition engine. The coupled model can qualitatively predict the experimentally obtained data with an improved performance for PRF, TPRF, and TPRF-ethanol surrogates.

STUDY ON EIGHT LUMPING DYNAMIC MODELS FOR FCC GASOLINE UPGRADING

Eight Lumps Kinetic Model for Residual Oil Catalytic Cracking

Lumped Kinetics Model and Its On-Line Application to Commercial Catalytic Naphtha Reforming Process

Modeling, Simulation and Optimization of Commercial Naphtha Catalytic Reforming Process

Nine Lumped Kinetic Models of FCC Gasoline under the Aromatization Reaction Conditions

An Introduction to the Lump Kinetics Model and Reaction Mechanism of Fcc Gasoline

Establishment of a model for calculating the blending octane numbers of blended gasolines

A Databased FCC On-line Steady State Optimization System

Establishment and Solution of Eight-Lump Kinetic Model for Fcc Gasoline Secondary Reaction Using Particle Swarm Optimization

A molecular-level coupling model of fluid catalytic cracking and hydrotreating processes to improve gasoline quality

Molecule Simulation for the Secondary Reactions of Fluid Catalytic Cracking Gasoline by the Method of Structure Oriented Lumping Combined with Monte Carlo

Study on Two-Step Process for FCC Gasoline Hydro-Upgrading

Development of a Reduced Four-Component (Toluene/n-Heptane/iso-octane/ethanol) Gasoline Surrogate Model

Dynamic Modeling and Simulation of FCCU Reactor-Regenerator System

A Study on FCC Gasoline Hydro-upgrading

Molecular level analysis on performance of diameter expanding reactor to improve gasoline quality in FCC process

ESTABLISHMENT OF LUMPED MODEL FOR HYDROTREATED RESIDUAL FLUID CATALYTIC CRACKING

Establishment of 14 Lumps Model for Fluid Catalytic Cracking of Hydrotreated Residuum

A Study on the Structure Oriented Lumping Model on the Catalytic Cracking of Straight-Run Gasoline

A New Lumping Kinetic Model for Fluid Catalytic Cracking

Upgrading FCC Gasoline Through Adsorption Separation of Normal Hydrocarbons