Abstract:Brake-by-wire systems are one of the key components in intelligent/unmanned vehicles that have attracted worldwide attention. Testing and evaluation of brake-by-wire systems are a significant step during the development of the technology of vehicular braking and further the advancement of intelligent/unmanned vehicles. Using the test bench to simulate different road adhesion coefficients (i.e. road surfaces) and to complete the testing and evaluation of the vehicle braking systems is of great significance and importance. A test bench for simulation of vehicular braking of 1/4 vehicle is presented and investigated in this article. It is composed of a motor, two rollers, a 1/4 vehicle suspension system, a magnetic powder clutch, a flywheel, sensors, a signal acquisition and processing system, and a controller. The wheel and vehicle speeds are simulated by the rollers and flywheel speeds, respectively. The translational kinetic energy of 1/4 vehicle is simulated by the rotational kinetic energy of the flywheel. The signal acquisition and processing system is used to acquire and process the experimental signals, such as rotational speeds and torques during tests. The magnetic powder clutch with adjusted applied currents in the test bench is used to real-timely simulate roads with different adhesion coefficients. Based on the working principle of the test bench and the fundamentals of vehicle dynamics, the prototype of the test bench is established and the simulation approach of the translational kinetic energy of 1/4 vehicle is investigated. The mathematical model of the real-time simulation about roads with different adhesion coefficients based on the magnetic powder clutch with real-time controllable transmitted torque is established. With the built 1/4 vehicle braking systems based on the test bench and road, and the corresponding established models, the comparison and analysis of the simulation results of various road surfaces are conducted. Experiments are sequentially implemented to verify the feasibility and effectiveness of the test bench.

Construction of Small Electric Vehicle Drive Motor and Its Controller Performance Test Rig

Control method of multi-motor's speed synchronization control in dynamometer test bench for multi-axles'vehicle

Design and Modeling of a Test Bench for Dual-Motor Electric Drive Tracked Vehicles Based on a Dynamic Load Emulation Method

An Automatic Testing System for Vehicle's Drive Axis Performance Test

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

Power Electronic Load System for Motor Drivers Testing Considering Motor Faulty Status Simulation

The Design of the Controller for Vehicle Brush-less DC Motor Based on LIN Bus

An Investigation into the Use of Hardware-in-the-loop Simulation Testing for Brushless DC Motor Drive of Hybrid Electric Vehicle

Design, modeling, and verification of a test bench for braking simulation of 1/4 vehicle

Design and research of permanent magnet synchronous motor controller for electric vehicle

Comparative Performance Evaluation of Hall Effect Sensorless Control Options in Permanent Magnet Brushless DC Motor Drives

Hybrid vehicle motor test platform development and application

A Mechanical-Hardware-in-the-Loop Test Bench for Verification of Multimotor Drivetrain Systems

Study on the Control of AC Dynamometer System for Hybrid Electrical Vehicle Test Bench

Development of test-bed controller for hybrid electric vehicle based on dual-motor load system

The Development of Dynamic Test Bench for EV Hybrid Brake System

A Study on the Control System of AC Dynamometer

Simulation of a permanent magnet brushless motor drive system for electric vehicles

Electric Vehicle Tires Test Bench Design for Laboratory

Drive System Design for Small Autonomous Electric Vehicle: Topology Optimization and Simulation

The Research and Development of Motor Cooling Control System Based on Electronic Parking Brake Test Bench