Abstract:Grain size engineering, particularly reducing grain size into the nanocrystalline regime, offers a promising pathway to further improve the strength-to-weight ratio of Al alloys. Unfortunately, the fabrication of nanocrystalline metals often requires non-equilibrium processing routes, which typically limit the specimen size and require large energy budgets. In this study, multiple dopant elements in ternary Al alloys are deliberately selected to enable segregation to the grain boundary region and promote the formation of amorphous complexions. Three different fully dense bulk nanocrystalline Al alloys (Al-Mg-Y, Al-Fe-Y, and Al-Ni-Y) with small grain sizes were successfully fabricated using a simple powder metallurgy approach, with full densification connected directly to the onset of amorphous complexion formation. All the compositions demonstrate densities above 99% with grain sizes <60 nm following consolidation via hot pressing at 585 °C. The very fine grain structure results in excellent mechanical properties, as evidenced by nanoindentation hardness values in the range of 2.2-2.8 GPa. Detailed microstructural characterization verifies the segregation of all dopant species to grain boundaries as well as the formation of amorphous complexions, which suggests their influential role in aiding effective consolidation and endowing thermal stability in the alloys. Moreover, nanorods with a core-shell structure are also observed at the grain boundaries, which likely contribute to the stabilization of the grain structure while also strengthening the materials. Finally, intermetallic particles with sizes of hundreds of nanometers form in all systems. As a whole, the results presented here demonstrate a general alloy design strategy of segregation and boundary evolution pathway that enables the fabrication of multiple nanocrystalline Al alloys with hierarchical microstructures and improved performance.

Nanocrystalline Ag formed by low-temperature high-energy mechanical attrition

Reforming Nanostructured CuAg Alloy to Improve Ductility and Electrical Conductivity

Strain-induced Refinement and Thermal Stability of a Nanocrystalline Steel Produced by Surface Mechanical Attritiontreatment

Formation of Nanocrystalline Fcc Phase by Mechanically Driven Crystallization

Amorphization in the AlC System by Mechanical Alloying

Nanocrystalline metals prepared by high-energy ball milling

Microstructure and Thermal Stability of Bulk Nanocrystalline Alloys Produced by Surface Mechanical Attrition Treatment

Nano-sized amorphous alumina particles obtained by ball milling ZnO and Al powder mixture

Nano-sized Amorphous Cu–Zr Alloy Particles Prepared by Mechanochemical Reaction

MECHANICAL BEHAVIOR OF NANOCRYSTALLINE METALS

High-speed impact behavior of cold-sprayed Fe-based amorphous particle on Mg alloy substrate

Heat treatment of bulk nanocrystalline Al-Zn-Mg-Cu alloy

Investigation of microstructure thermal evolution in nanocrystalline Cu

Synthesis of nanocrystalline intermetallic layer by mechanical attrition

Ag surface diffusion and out-of-bulk segregation in CrN-Ag nano-composite coatings

Microstructure and thermal stability of nanocrystalline Mg-Gd-Y-Zr alloy processed by high pressure torsion

Surface Nanocrystallization of Mg-3 Wt.% Li-6 Wt.% Al Alloy by Surface Mechanical Attrition Treatment

The Preparation of Nanograin Ag–TCNQ Thin Films by Vacuum Evaporation with Post-Heat Treatment

Surface Grain Refinement of AZ91D Magnesium Alloy by Cold Spraying Shot Peening Process

Microstructural Stability of Gas-Atomized Al-Based Nanophase Composites.

Bulk nanocrystalline Al alloys with hierarchical reinforcement structures via grain boundary segregation and complexion formation