Abstract:In this work, a facile route using a simple solvothermal reaction and sequential heat treatment process to prepare 3D La2O3 flower-like nanostructures without employing templates or matrices for self-assembly is presented. The as-synthesized products were characterized by powder X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), high-resolution TEM (HRTEM), energy dispersive X-ray spectroscopy (EDS), thermogravimetric analysis (TG), differential thermal analysis (DTA), and Fourier transformation IR (FTIR). SEM results demonstrate that the as-prepared flower-like precursor with average size of 5-7 mu m in diameter is composed of numerous nanoplates with a thickness of about 100 nm. Influencing factors such as solvothermal reaction temperature, surfactants, reaction time, and solvents were systematically investigated. 3D flower-like La2O3 nanostructures with many holes on the petals were obtained after calcinations of the flower-like precursor at 800 degrees C for 4 h. The BET surface area of the flower-like La2O3 nanostructures is 9.98 m(2)/g. Eu3+ doped flower-like La2O3 nanostructures were also prepared employing the same preparation process. The flower-like La2O3:Eu3+ nanostructures show a strong red emission corresponding to D-5(0)-F-7(2) transition (625 nm) of Eu3+ under ultraviolet excitation (267 nm). The possible formation mechanism for the 3D flower-like precursor was briefly discussed.

Synthesis and Thermodynamic Analysis of Nano-La2o3

Low-temperature chemical solution synthesis of dendrite-like La(OH) 3 nanostructures and their thermal conversion to La 2 O 3 nanostructures

Synthesis of Nanocrystalline Ferrites Zn0.4ni0.6cr0.5laxfe1.5-Xo4 and Its Magnetic Properties

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

Synthesis of Ultrafine Lanthanum Hydroxide Nanorods by A Simple Hydrothermal Process

Preparation and characterization of lead-free Na0.54K 0.42Li0.04NbO3 nano-powders by sol-gel method

Preparation Of Nanocrystalline La2o3 By Sol-Gel Method

Synthesis and microstructure of La-doped ceria nanoparticles.

Preparation and Characterization of Lead-Free Na0.54K0.42Li0.04NbO3 Nano-Powders by Sol-Gel Method

Preparation of nano-sized lanthanum oxide by ultrasonic-homogeneous precipitation method

Synthesis and performances of nano-sized neodymium oxide

The study on preparation and thermal stability of nanocrystalline LaF3 bulk material

Synthesis Of Nanostructure Lamno3 And Lacoo3 Catalysts And Their Catalytic Activity In Oxidation Reaction

Investigating the physical and electrical properties of La2O3 via annealing of La(OH)3

Kinetics investigation of oxygen storage capacity in La 2O 3-CeO 2 solid solution

Preparation and Characterization of 3d Flower-Like La2o3 Nanostructures

Synthesis and transport properties of La2NiO4

Research Progress in Preparation Methods of Nanometer La_2O_3 and Its Composite Oxides

Synthesis of Lanthanum Hydroxide Nanorods in the Media of Reverse Microemulsions

Hydrothermal Synthesis and Characterization of Rare Earth Compound Nanoparticles and Nanorods