Abstract:For silicon solar cells, polysilicon‐based passivating contacts exhibit excellent gettering effects during high‐temperature fabrication process. This study confirms that both n‐ and p‐type polysilicon passivating contacts show stable and robust performance to iron gettering. However, iron gettering to the front p‐type emitter is found to degrade the emitter saturation current. The polysilicon‐based solar cells with significant initial bulk iron contamination exhibit lower Voc and Jsc values, interestingly, as well as an increased ideality factor and worse temperature coefficient in Voc. Over the past decade, silicon solar cells with carrier‐selective passivating contacts based on polysilicon capping an ultra‐thin silicon oxide (commonly known as TOPCon or POLO) have demonstrated promising efficiency potentials and are regarded as an evolutionary upgrade to the PERC (passivated emitter and rear contact) cells in manufacturing. The polysilicon‐based passivating contacts also exhibit excellent gettering effects that relax the wafer and cleanroom requirements to some extent. In this work, we experimentally explore the impact of bulk iron contamination and polysilicon gettering on the passivation quality of the polysilicon/oxide structure and the resulting solar cells performance. Results show that both n‐ and p‐type polysilicon/oxide passivating contacts are not affected by iron gettering, demonstrating robust and stable passivation quality. However, for a very high bulk iron contamination (1 × 1013 cm−3), the accumulated iron in the p‐type lightly boron‐doped emitter in crystalline silicon would degrade the emitter saturation current density. This can cause a reduction in both open‐circuit voltage and short‐circuit current. Meanwhile, this very high iron content (1 × 1013 cm−3) can further degrade the fill factor and temperature coefficient of the cells. On the other hand, for an initial iron content of 2 × 1012 cm−3, which should be well above the iron level in the current industrial Czochralski silicon wafers, the resulting cells demonstrate similar performance as the control group with no intentional iron contamination. This work brings attention to both the benefits of polysilicon gettering effects as well as the potential degradation due to the accumulation of metal impurities in the p‐type emitter region.

Analysis Pollutant Production and Discharge in high-purity polysilicon industry of solar cell

Progress in Preparation Technology of Polysilicon

A High-Efficiency and Energy-Saving Method for Purifying Industrial Silicon for Silicone Use

Research on Carbon Emission of Solar Grade Polysilicon Produced by Metallurgical Route Using Digital Simulation Technology

Study on the Removal of Impurities in Silicon by Electrorefining

PURIFICATION AND CHARACTERIZATION OF METALLURGICAL GRADE SILICON BY THREE-LAYER ELECTROREFINING

Role of polysilicon in poly-Si/SiOx passivating contacts for high-efficiency silicon solar cells

Recent Advances in Electrochemical-Based Silicon Production Technologies with Reduced Carbon Emission

Polysilicon Passivating Contacts for Silicon Solar Cells: Interface Passivation and Carrier Transport Mechanism

Effect of Iron Contamination and Polysilicon Gettering on the Performance of Polysilicon‐Based Passivating Contact Solar Cells

ENVIRONMENTAL POLLUTION OF SOLAR PANEL PRODUCTION IN OUR COUNTRY

A comprehensive hydrometallurgical recycling approach for the environmental impact mitigation of EoL solar cells

Progress in screen-printed metallization of industrial solar cells with SiOx/poly-Si passivating contacts

Low-cost solar grade silicon purification process with Al–Si system using a powder metallurgy technique

Method for preparing high purity polysilicon particle with fluidized bed and bed fluidizing reactor

CFD-Aided Design for Polysilicon Production System

Recent Patenting Activities in Low-Cost Silicon Raw Materials for Silicon Solar Cells

Study on the Separation and Sedimentation Performance of Silicon from Diamond Wire Saw Silicon Powder Slurry

Study on energy consumption optimization of polysilicon reduction furnace

Economic Measurements of Polysilicon for the Photovoltaic Industry: Market Competition and Manufacturing Competitiveness

Numerical simulation of granular silicon growth and silicon fines formation process in polysilicon fluidized bed