Abstract:During plasma spraying, SiC particles undergo sublimation, accompanied by the sublimation and decomposition of Si and C atoms in the crystal lattice. Ultimately, the deposited SiC either spreads splash or breaks apart on the surface of the carbon‐carbon composite matrix. It is widely known that silicon carbide (SiC) is challenging to thermal spray. However, the nature of deposition and the underlying mechanisms are still not clearly understood. In the current work, the process of atmospheric plasma‐sprayed SiC was investigated in detail. SiC exhibits sublimation severely under the plasma spraying (PS). More than 65 mol.% SiC particles lost by sublimation during PS estimated by calculation. Due to the nonuniformity of temperature in plasma flame, a small amount of SiC particles was retained. Moreover, a small amount of Si and SiO2 was experimentally observed after deposition process from the single‐splat characterization. According to the first‐principles calculations, the detachment energy of C atom from the lattice (0.591 eV) is lower than that of Si atom (1.257 eV). The adsorption energies of an O atom on the Si‐ and C‐terminated surfaces are −9.549 and −7.631 eV, respectively. Therefore, C is more likely to form gaseous products after decomposition, and Si is more likely to be retained to form Si and SiO2. Mullite was found on the grain boundaries of molten Si, which was attributed to the rapid diffusion of the Al2O3 substrate along the grain boundaries of Si, promoting the spreading of molten splats. It is difficult to stack particles through self‐diffusion among SiC particles to form coatings. The discovery on thermal deposition mechanism of SiC in PS is helpful to promote the practical application of SiC coatings on preparation optimization and interfacial bonding improvement.

SPRAY PELLETIZATION PROPERTIES OF AQUEOUS SIC SLURRY

EFFECT OF SPRAY PELLETIZATION ON SOLID-STATE SINTERING OF SiC CERAMIC MATERIALS

DISPERSIBILITY MECHANISM AND SPRAY DRYING OF SiC AQUEOUS SLURRY

Rheological properties and spray-drying behaviors of nano-SiC based aqueous slurry

Characteristics and Sintering Behaviors of SiC-AIN Composite Powders Obtained by Spray Drying

Influence of Silane Coupling Agent and Anionic Dispersant on the Dispersion Effect of Silicon Carbide Particles

Ultra-Fine Treatment of Sic Powder and Its Effect on Microstructure and Properties of Sic Ceramic

Rheological Properties,dispersibility and Stability of Nano-Sic Based Aqueous Slurry

Influence of surface oxide layer of SiC powder on the rheological properties of its slurry

THE STUDY OF THE SLURRY PROPERTIES OF Si_3N_4 FOAM CERAMICS

Deposition behavior and mechanism of thermal sprayed SiC

Effect of the SiC powder microscopic morphology on properties of Si/SiC ceramics prepared by spark plasma sintering

Preparation of silicon carbide ceramic slurry for stereolithography based additive manufacturing

Studies of synthesizing the SiC nanometer powders by chemical vapor reaction

Investigation of Compaction and Sintering Behavior of SiC Powder after Ultra-Fine Treatment.

Surface modification of superfine SiC powders by ternary modifiers-KH560/sodium humate/SDS and its mechanism

Gelcasting of Concentrated Aqueous Silicon Carbide Suspension

Composite modification of fine SiC powder by 3-aminopropyl triethoxysilane and sodium polystyrene sulfonate and its slip casting study

DISPERSION AND RHEOLOGICAL PROPERTY OF THE CONCENTRATED SiC SUSPENSION

Effect of Different Particle Sizes and Pore-Making Agent Ratio on Properties of SiC Porous Ceramics

Preparation and characterization of Cr 2 AlC microspheres prepared by spray-drying granulation