Abstract:This paper describes the radio frequency (RF) measurement and tuning result of a 13 MeV Alvarez-type drift tube linac (DTL) for a compact pulsed hadron source (CPHS) at Tsinghua University. The design, machining, assembly, and alignment of the DTL are presented for integrity. The CPHS project consists of a high-current proton linac (13 MeV, 16 kW, peak current of 50 mA, 0.5 ms pulse width at 50 Hz), a neutron target station, a small-angle neutron scattering instrument, and a neutron imaging/radiology station. The linac contains an electron cyclotron resonance ion source, a low energy beam transport line, a four-vane radio frequency quadrupole (RFQ) accelerator, an Alvarez-type DTL, a high energy beam transport line, and a RF power supply and distributor. Construction on the CPHS started in June 2009, and the CPHS has provided 2000 h since 2013 to users with the neutrons produced by the 3 MeV proton beam from the radio frequency quadrupole bombarding on the beryllium target as an achievement of its mid-term objective. Presently, the tuning of the assembled DTL cavity has been completed successfully. The 4.3-m-long DTL consists of 40 accelerating cells, among which 39 full-length drift tubes (DTs) are suspended inside the cavity, and two half-length DTs are mounted inside the two end flanges of the cavity. Each DT contains a permanent magnet quadrupole. Thirteen post couplers and nine tuners are available for the tuning of the field. The relative error of the field after tuning is within ±1.6%, with a tilt sensitivity within ±33%/MHz in all cells. The beam energy will reach its designed value of 13 MeV after the DTL is installed in the beam line downstream the 3 MeV RFQ accelerator.

The Design and Initial Testing of the Beam Phase and Energy Measurement System for DTL in the Proton Accelerator of CSNS

A beam phase and energy measurement system based on direct RF signal IQ under-sampling technology

A Beam Phase and Energy Measurement Instrument Based on Direct RF Signal IQ Undersampling Technique

Beam instrumentation system development and commissioning in ssrf

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

Design and Measurement of Signal Processing System for Cavity Beam Position Monitor

DTL construction status of China Spallation Neutron Source

Beam Position and Phase Measurement System for the Proton Accelerator in ADS

Radio frequency measurement and tuning of a 13 MeV Alvarez-type drift tube linac for a compact pulsed hadron source

The Proton Beam Real-time Monitor System in CSNS

Beam Position Monitors As Precise Phase Pickups for Beam Energy Measurement at the Compact Pulsed Hadron Source

The accelerator control system of CSNS

Development of the double spoke cavity prototype for CSNS-II

Neutron Beam Line Design of a White Neutron Source at CSNS

PRIMARY DESIGN OF DTL FOR CPHS

Design and beam dynamics simulation of an 8 MeV compact accelerator-driven neutron source

Design and performance of LLRF system for CSNS/RCS

Preliminary Design of CSNS-II Linac SRF LLRF

Application of Real-time Digitization Technique in Beam Measurement for Accelerators

High precision proton beam monitor system concept design on CSNS based on SiC

Beam Dynamic Design and Study of a Linac with Variable Output Energy for an AB-BNCT Facility