Effect of Sintering Temperature on Thermoelectric Properties of La-doped SrTiO3 Ceramics Prepared by Sol–gel Process and Spark Plasma Sintering

Peng-Peng Shang,Bo-Ping Zhang,Jing-Feng Li,Ning Ma
DOI: https://doi.org/10.1016/j.solidstatesciences.2010.05.005
IF: 3.752
2010-01-01
Solid State Sciences
Abstract:Single-phase polycrystalline La0.08Sr0.92TiO3 ceramics were prepared by spark plasma sintering (SPS) using sol-gel-derived powders. The La0.08Sr0.92TiO3 bulks had highly relative density (similar to 92%), and the grain size of the samples obviously grew from 300 nm to 3 mu m when the SPS temperature increased from 1203 to 1473 K. The electrical conductivity increased with SPS-processing temperature owing to the increase of relative density, grain size, and oxygen vacancies due to the reducing atmosphere of SPS. The absolute value of Seebeck coefficient increased as the SPS temperature increased from 1203 to 1373 K. and then decreased by further increasing SPS temperature to 1473 K. The sample SPSed at 1373 K had the largest absolute value of Seebeck coefficient of 196 mu VK-1 at 679 K. Sol-gel process and SPS can significantly decrease the thermal conductivity of SrTiO3 based ceramics, whose lowest value was reduced to 1.19 Wm(-1)k(-1) at 773 K in the sample SPSed at 1203 K. The maximum ZT value of 0.08 was obtained at 679 K for the sample SPSed at 1473 K. (C) 2010 Elsevier Masson SAS. All rights reserved.
What problem does this paper attempt to address?