Abstract:Due to the existence of an acid etch resistant thin amorphous silicon layer over the smooth grooves of the diamond wire sawing polycrystalline silicon wafer surface, the anti-reflection effect is usually not ideal using the mature acidic texturization. The amorphous silicon layer will be produced on the machined surface by material ductile removal. Therefore, during the process of cutting photovoltaic polycrystalline silicon wafers, the material removed in the brittle way is expected and the surface topography of the wafers formed with the brittle fracture is better for the texture fabricating. In this paper, a mathematical model considering the influences of process parameters and wire saw parameters was developed based on indentation fracture mechanics. The variations of cutting groove profile formed by different material removal modes were also included. The effect of abrasives distributed on the wire saw on material removal and surface formation of polysilicon was analyzed. The results showed that most of abrasives removed material with ductile removal mode, however, the volume of the material removed by abrasive in ductile mode is less than 10% of the total removal volume. Brittle fracture removal mode was still the major way of material removal in diamond wire sawing. With the same ratio of the feed rate and wire speed, the faster feed rate and wire speed will not only improve the cutting efficiency, but also is easier to obtain a brittle fracture surface. There is a critical angle θ c for the distribution of abrasives on the wire saw surface. Only when the position angle of the abrasive removing material in brittle mode is less than θ c , the brittle fracture can be formed on the wafers surface.

Effect of Roughness and Wettability of Silicon Wafer in Cavitation Erosion

A Study on Surface Topography in Cavitation Erosion Tests of AlSi10Mg

On Mechanism of Cavitation Erosion of Rough Surface

Influences of the Viscosity of Slurry on Monocrystalline Silicon Surface Damage Caused by Nanoparticle Impact

Mechanical effect of abrasives on silicon surface in chemo-mechanical grinding

Ductile deformation and subsurface damage evolution mechanism of silicon wafer induced by ultra-precision grinding process

Study on Material Damage Process of Si under Rotating Disk Test

Experimental Study of Cavitation Damage on Hydrogen-Terminated and Oxygen-Terminated Diamond Film Surfaces

Effect of Initial Surface Roughness on Cavitation Erosion Resistance of Arc-Sprayed Fe-Based Amorphous/Nanocrystalline Coatings

Effect of Processing Methods and Type of Materials on Cavitation Erosion

Erosion characteristics and failure mechanism of reservoir rocks under the synergistic effect of ultrasonic cavitation and micro-abrasives

The effect of cut depth and distribution for abrasives on wafer surface morphology in diamond wire sawing of PV polycrystalline silicon

An Investigation on the Monocrystalline Silicon Surface Damage Caused by Slurry Erosion

Study on Controllable Wettability of Roughness Surfaces

Experimental Study on the Influence of Wire-Saw Wear on Cutting Force and Silicon Wafer Surface

Study on the Vertical Ultrasonic Vibration-Assisted Nanomachining Process on Single-Crystal Silicon

Comparison of surface damage under the dry and wet impact: Molecular dynamics simulation

Material removal and damage formation mechanisms induced by periodic indentation during ultrasonic vibration-assisted scratching of SiC f /SiC composites

Effects of Vapor Environment and Counter-Surface Chemistry on Tribochemical Wear of Silicon Wafers

Surface damage in wire-cut silicon wafers

Surface and subsurface cracks characteristics of single crystal SiC wafer in surface machining