Abstract:Scanning x-ray microbeam topography and fluorescence experiments were conducted in situ to study the electromigration behavior of a 0.5 μm thick, 10 μm wide, and 200 μm long Al(0.25 at. % Cu) conductor line with 1.5 μm-thick SiO2 passivation on a single crystal Si substrate. The strain sensitivity of x-ray topography measurement allowed detailed examination of the electromigration-induced stress distribution and evolution in the conductor line in response to the depletion of Cu solute early in the electromigration process. Upon electromigration at 0.4 MA/cm2 and 303 °C, a short-range stress gradient was quickly induced by Al migration in the Cu-depleted cathode region to counteract further Al flow. The stress gradient was fully developed during the 5.3 h incubation time, extending over the critical Blech length of about 66 μm from the cathode end. Plastic deformation then occurred at the downstream end of the Cu-depleted region. The preferential electromigration of Cu did not cause detectable stress change outside the Cu-depleted region, except for the significant stress development from the Al2Cu precipitation at the anode end which appeared to initiate the fracture in the passivation. Preliminary finite difference modeling was undertaken to simulate the experimental observations, from which important parameters dictating electromigration in Al(Cu) line were extracted: an apparent effective valence of −5.6 and −1.9 for Cu and Al in Al(Cu), respectively, and a critical Cu concentration of 0.16 at. % above which Al grain boundary diffusion is effectively blocked.

Electromigration Studies of Cu/Carbon Nanotube Composite Interconnects Using Blech Structure

Copper/carbon nanotube composite interconnect for enhanced electromigration resistance

Modeling of Carbon Nanotube Interconnects and Comparative Analysis with Cu Interconnects

Modeling of carbon nanotube (CNT) interconnects

High-Frequency Analysis of Cu-Carbon Nanotube Composite Through-Silicon Vias

Near-Field Radiated from Carbon Nanotube and Graphene-Based Nanointerconnects

Electrothermal Characterization of Single-Walled Carbon Nanotube (SWCNT) Interconnect Arrays

Circuit Modeling and Performance Analysis of Multi-Walled Carbon Nanotube Interconnects

Comparison of the Time-Dependent Physical Processes in the Electromigration of Deep Submicron Copper and Aluminum Interconnects

Reservoir Effect and the Role of Low Current Density Regions on Electromigration Lifetimes in Copper Interconnects

Reliability Evaluation of Carbon Nanotube Interconnect in a Silicon CMOS Environment

Understanding the Impact of Surface Engineering, Structure, and Design on Electromigration Through Monte Carlo Simulation and In‐Situ SEM Studies

Remedies to Control Electromigration: Effects of CNT Doped Sn-Ag-Cu Interconnects

Aqueous electromigration of single-walled carbon nanotubes and co-electromigration with copper ions

Electromigration in Cu–Cu joints: Measurement of activation energy and polarity effect

Characterization of electromigration-induced short-range stress development in Al(0.25 at. % Cu) conductor line

On Transport Properties of CNT Metal/semiconductor/metal Heterostructures Using First Principles Methods

Reliability Studies of Barrier Layers for Cu/PAE Low-K Interconnects.

MEMS-based Carbon Nanotube and Carbon Nanofiber Cu Micro Special Electric Contact

Finite Element Analysis Of Electromigration Reliability In Copper Chip Interconnect

Improvement of Interface and Electrical Properties in Carbon Nanotube/nanocrystalline Copper Composite Films