Abstract:Blank holder force (BHF) is one of the important process parameters in the deep drawing process. BHF helps produce defect-free components by controlling metal flow during the deep drawing process. If BHF is low, it causes wrinkling; otherwise, it causes the sheet to rupture. Therefore, optimization of BHF is an important issue in industries. One of the effective approaches to determining optimal BHF is to study forming force, thickness distribution, and wrinkles to produce a deep-drawn cup. The main function of this approach is that it minimizes the maximum forming force and prevents process limits. Therefore, this study aims to investigate the relationship between the BHF and forming force through experimental and simulation results. In addition, the effect of BHF on the thickness distribution and wrinkling is considered. Hence, numerical and experimental methods were employed for St14 and SS304L sheets with thicknesses of 0.5, 1, and 1.5 mm to achieve the objectives. Firstly, the simulation of the process was performed to study the mechanical behavior. Then, a set of experimental tests were conducted to validate the simulations. Finally, utilizing the experimental and numerical results, the optimal BHF value was determined. It was observed that the maximum thinning and maximum forming force are related to the forming process without BHF. Moreover, when the wrinkling at the edge of the part was removed by gradually increasing BHF, the minimum values of forming force and thinning were obtained. According to the investigations carried out on three thicknesses, it was observed that by reducing the thickness from 1.5 to 0.5 mm, the maximum forming force decreases in both SS304L and St14 sheets. However, the acquired results showed that the minimum optimal BHF is obtained in both sheets at a thickness of 1.5 mm. Overall, this research provides valuable experimental and numerical guidance for implementing the deep drawing process to manufacture cylindrical parts with minimum forming force required to save energy consumption.

The Effect of Binder Layouts on the Sheet Metal Formability in the Stamping with Variable Blank Holder Force

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Design and Application of a Novel Cone-shaped Blank Holder for Precision Stamping Process

Effect of the Friction on the External High Pressure Forming of Metal Stator Screw Lining

Research on the Critical Blank Holder Force of Elliptical Heads

Modelization And Simulation Of Sheet Forming Process Closed-Loop Control System Based On Time Series Analysis Theory

Development of forming process for deep drawing of square cup with optimized blank holder pressure

FEM model optimization study of mechanical properties and material selection in stamping process

Effect of blank holder force on joining quality of the flat clinch-rivet process

Effect of Stiffeners on Mechanical Behavior of T-Stubs Based on Experiment and Numerical Simulations

Die Structure Analysis Of Stress Distribution During High-Strength Steel Stamping Process And Experimental Validation

Structure Design on Thermoplastic Composites Considering Forming Effects

Influence and improvement of stamping process parameters on V-shaped clamp forming quality

Experimental and numerical investigation to determine the optimal blank-holder force in deep drawing process based on forming force for SS304L and St14 sheets

Computational modelling of postbuckling behavior of composite T-stiffened panels with different bonding methods

Study on Optimized Control of BHF

The influence of different compositions of fiber metal laminates on the fracture in the semi-solidified stamping forming

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

Machine learning in the prediction of formability in aluminum hot stamping process with multiple variable blank holder force

Analysis of Sheet Metal Forming (Stamping Process): A Study of the Variable Friction Coefficient on 5052 Aluminum Alloy

Study on the Effect of the Pre-Forming of 22MnB5 Steel in Indirect Hot Stamping