Abstract:Alloy 2060, a new generation of aluminum–lithium (Al-Li) alloy, is widely used for aviation structural parts due to its high-specific strength and high-specific stiffness. However, poor formability of Al-Li alloy is commonly exhibited at room temperature. In this paper, the formability of Al-Li alloy 2060 was studied under the conditions of elevated temperatures. The Marciniak–Kuczynski (M–K) model was developed to effectively predict the forming limit curves (FLCs) under hot stamping conditions. Firstly, the hot tensile test was conducted to investigate the high-temperature deformation behaviors, and the Fields–Backofen equation was calibrated to represent the flow stress of the alloy. Then, the isothermal hemispherical punch tests were proposed to obtain the FLCs of Al-Li alloy 2060. Finally, the FLC predicted by the M–K model was input into the deep drawing finite element simulation model to verify the accuracy of the prediction results and predict the possible fracture of the hot stamping parts. The cup-shaped deep drawing test and the thin-walled shell part hot stamping test were carried out to verify the accuracy of the FLCs and the formability of the Al-Li alloy 2060. The results show that the true stress increases with the strain rate increasing and decreases with the temperature increasing. The established M–K model can accurately predict the FLCs of alloy 2060. It is also found that the initial thickness imperfection factor f0 is an important parameter that determines the change of FLC. Comparing the experimental and simulation results, it is concluded that the established M–K model would be adaptable in the FE simulation to estimate if the fracture of parts occurs. The simulation model considered the FLC can predict the fracture, thinning, and wrinkle of the parts. The stamping depth increases with the deformation temperature increasing and the blank holder force decreasing.

Machine learning in the prediction of formability in aluminum hot stamping process with multiple variable blank holder force

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Clamping force prediction for automatic drilling of stacked thin-walled workpieces based on finite element method

The prediction of part thickness using machine learning in aluminum hot stamping process with partition temperature control

Formability Prediction Using Machine Learning Combined with Process Design for High-Drawing-Ratio Aluminum Alloy Cups

FEM model optimization study of mechanical properties and material selection in stamping process

Numerical Optimization of Variable Blank Holder Force Trajectories in Stamping Process for Multi-Defect Reduction

M–K model based forming limit prediction of aluminum–lithium alloy 2060 and its application in hot stamping

Control of the blank-holder force to improve the formability of aluminum alloy sheet

A New Strategy to Optimize Variable Blank Holder Force Towards Improving the Forming Limits of Aluminum Sheet Metal Forming

Investigation of the Hot-Stamping Process for Advanced High-Strength Steel Sheet by Numerical Simulation

Prediction on Die Structure Performance During Advanced High-Strength Steel Sheet Metal Stamping with Non-Rigid Tooling Definition

Digital Twin-Driven Sheet Metal Forming: Modeling and Application for Stamping Considering Mold Wear

Numerical simulation of hot stamping for high strength steel

Novel algorithm for determining optimal blankholder forces in deep drawing of aluminum alloy sheet

Modelization And Simulation Of Sheet Forming Process Closed-Loop Control System Based On Time Series Analysis Theory

Effect of variable blank-holder forces on the formability of aluminum alloy sheets during sheet metal forming

A General IHTC Model for Hot/warm Aluminium Stamping

Application of Artificial Intelligence Extrusion Die Model Based on Finite Element Simulation in Decorative Material Aluminum Alloy

Prediction of tensile strength using machine learning algorithms in fused deposition modeling

Multi-Objective Optimization of Process Parameters in 6016 Aluminum Alloy Hot Stamping Using Taguchi-Grey Relational Analysis