Abstract:Indium (III) and tin (IV) hydroxides (precursor) were synthesized by a co-precipitation process at the different reaction temperature in a water bath. Nanocrystalline indium tin oxide (ITO) powders with spherical and rod shapes were obtained upon calcination. The phase transformations during calcination process in Ar gas at ambient temperature −1100°C were investigated by TG/DTA system, X-ray diffraction and transmission electron microscopy. A mixture of In(OH)3, InOOH and Sn3O2(OH)2 preferred the path of pure In(OH)3→In2O3 during calcinations in Ar gas and the powders with rhombohedral and cubic structured crystalline ITO were obtained at 600°C. The crystal parameters changed with calcination temperature. Oxygen vacancies were developed at about 400°C determined by resistivity decrease and the color change of powders. Characterized by TEM and FESEM, the spherical and rod shapes of the particles were prepared at bath temperature of 40 and 100°C, respectively, and remained after calcination in Ar gas. The particles’ size showed obvious shrinkage compared with the precursors. At higher bath temperature In(OH)3 octahedral nuclei in the cubic structure cell stacks along the closest plane (100) and evolves nano-rod due to the influence of NH4+ on the orientation of crystals.

Monodispersed Tin Doped Indium Oxide Nanometer Powders Prepared by Hydrothermal Method

Preparation of Monodispersed Tin-Doped Indium Oxide Nanopowders under Moderate Conditions

Synthesis of Tin-Doped Indium Oxide Nanoparticles by an Ion-Exchange and Hydrothermal Process

Synthesis and sintering of tin-doped indium oxide nanoparticles with uniform size

Preparation and Sintering Behavior of the Tin-Doped Indium Oxide Nanopowders: Rapid Communications of the American Ceramic Society

Preparation of Nano-sized Powder of Indium Tin Oxide (ITO)

Study on Preparing Nanosized ITO Powder by Chemical Liquid Phase Coprecipitation Process

Preparation of Nano-Powders of ITO

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

PEG-assisted Synthesis of Tin-doped Indium Oxide Nanopowders by Sol-gel Method

Optimized Design for Preparing Nanocrystalline ITO Powder

Synthesis of Ito Nanoparticles by Coprecipitation Method

Novel Preparation Process of Nanosized ITO Powder by Chemical Liquid Phase Coprecipitation

Hydrothermal Synthesis of Tin Oxide Nanoparticles

Preparation of ITO Nano-Powders by Hydrothermal-Calcining Process

A Sol–gel Method to Synthesize Indium Tin Oxide Nanoparticles

Preparation and Characterization of Nanosize Indium-Tin-Oxide Powder by Chemical Co-precipitation

A Cost-Effective Co-precipitation Method for Synthesizing Indium Tin Oxide Nanoparticles Without Chlorine Contamination

Preparation of Ultra-Fine Indium Tin Oxide Powders with High Specific Surface Areas by Co-Precipitation Method

Effects of Temperature on Indium Tin Oxide Particles Synthesized by Co-Precipitation

Synthesis of indium tin oxide nano-polycrystalline powders by ultrasonic spray pyrolysis