Abstract:An experimental simulation study on the transition from pressurized to boiling operation of a low-temperature, natural circulation nuclear heating reactor (5 MW) developed by INET of Tsinghua University is presented. The experiment was performed on the test loop (HRTL-5), which simulates the geometry and system design of the 5 MW reactor. The manifestation of different kinds of two-phase flow instabilities, namely geysering, flashing instability and low-steam quality density wave instability on the transition from pressurized to boiling operation is described. The mechanism of flashing instability, which has never been studied well on this field, is especially interpreted. It is suggested that the start-up process, from initial condition to boiling operation condition, should consist of three steps: (1) increasing of initial pressure by means of a noncondensable gas (N2), which is a very effective method to eliminate geysering and flashing instability at lower pressure. (2) start-up of the reactor at this pressurized condition with a constant heat flux under the limited value of 9 = 0.15 MW ?m-2, which controls the exit temperature of the heated section below the one of net vapor generation, the low steam quality density wave oscillation can be avoided. (3) transition to a lower pressure, boiling operation. The method of transition with low-heat flux and low-inlet subcooling is proposed: at pressurized operation condition, by reducing the heat flux to its lowest level, releasing the noncondensable gas and increasing the heat flux gradually (dq/dt3 kW ?m- 2 ?min-1l) , during which the low-steam quality density wave oscillation can be be prevented from occurring, then the boiling operation condition can be achieved through adjusting the heat flux and inlet subcooling to their designed value. A stable transition from pressurized to boiling operation of the 5 MW reactor is achieved by careful selection of the thermohydraulic parameters.

Experimental-Study And Operation Experiences Of The 5 Mw Nuclear Heating Reactor

Operational and Experimental Study of Nhr-5

The Design Characteristics And Construction Experiences Of The 5 Mwt Nuclear Heating Reactor

OV / 4-5 1 Overview of Experimental Results on the HL-2 A Tokamak

Overview of Experimental Results on the HL-2A Tokamak

Some Features Of The Nuclear Heating Reactor (Nhr) Design In China

Experimental study on 5 MW Nuclear Heating Reactor Refrigeration

Experimental Simulation Study On Start-Up Of The 5 Mw Nuclear Heating Reactor

Experimental simulation on transit process of the 5MW nuclear reactor

Thermalhydraulic Investigation Using a Test Facility Simulating 200 MW Integral Heating Reactor

Chinese Nuclear Heating Test Reactor And Demonstration Plant

Investigation on heat-electricity cogeneration with nuclear heating reactors

Nuclear Heating Reactor, an Advanced and Passive Reactor

Thermo-hydraulic Experimental Validation of an Integrated Modular Small Reactor Operating in Full Power Natural Circulation

Study on dynamic character of thermohydraulic test system of 5MW low temperature nuclear heating reactor

Reactor physics analysis of nhr200-ii heating reactor using rmc monte carlo code

Investigation on thermohydraulic characteristics of novel superheated steam supply system for low temperature nuclear heating reactor

Experimental and Operational Verification of the HTR-10 Once-Through Steam Generator (SG): Heat-transfer and Hydrodynamic Features of the Once-Through Steam Generator

Research on Power Regulation and Distribution of the Improved NHR200-II Low Temperature Nuclear Heating Reactor

Technical Design-Features And Safety Analysis Of The 200 Mwt Nuclear Heating Reactor

Experimental Investigation on Flow Behavior During Start-up of a Heating Reactor