Experimental Simulation Study On Start-Up Of The 5 Mw Nuclear Heating Reactor

S.Y. Jiang,M.S. Yao,J.H. Bo,S.R. Wu

DOI: https://doi.org/10.1016/0029-5493(95)01020-I

IF: 1.7

1995-01-01

Nuclear Engineering and Design

Abstract:An experimental simulation study on the start-up of a low temperature, natural circulation nuclear heating reactor (5 MW developed by the Institute of Nuclear Energy of Tsinghua University, Beijing) is presented. The experiment was performed on the test loop (HRTL-5), which simulates the geometry and system design of the 5 MW reactor. The manifestation of different kinds of two-phase flow instability, namely geysering, flashing instability and low steam quality density wave instability on the start-up are described. The mechanism of flashing instability, which has never been well studied in this field, is especially interpreted. Based on the study of these instabilities', it is suggested that the start-up process, from initial condition to boiling operation condition, should consist of three steps: increasing of initial pressure by means of a noncondensable gas (N-2), start-up of the reactor at this pressurized condition (single-phase regime operation), and transition to a lower pressure, boiling operation. Three transition methods are discussed. As a result of these studies, the method of transition with low heat flux and low inlet subcooling is proposed. A stable start-up process of the 5 MW reactor is achieved by careful selection of the thermohydraulic parameters.