Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

A Study on Influence of Temperature and Uprightness on Stability of Thin-Wall High-Pier Continuous Rigid Frame Bridge

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Study on Ultra‐low Cycle Fatigue Fracture of Thick‐walled Steel Bridge Piers

Stability Analysis of Yinxian Second Bridge

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

New Advances In Theory Of Stability Of Steel Structures

Temperature Field and Stress Field of Prestressed Concrete Box-Girder Bridge

The Influence of Buckling Mode and Buckling Stability Coefficient of Rigid-Frame Bridge during Construction in Cold Region

Analysis of Sensitive Factors of Long-Span Continuous Rigid Frame Bridge'S Stability with Thin-Wall Piers in the Construction Stage

Analysis of Temperature Stress in Bridges Considering Vertical and Transverse Temperature Gradient

Study of Dynamic Behavior and Influences Induced by Structural Parameter Variations of Self-Anchored Suspension Bridge

Effect analysis of temperature in the large continuous rigid frame bridge

Seismic Analysis of Long Span Continuous Rigid-Frame Bridge with Thin-Walled High Piers

Stability analysis of the steel structure of tianjin bengbu bridge

Spatial Analysis of Self-anchored Suspension Bridge and Its Experimental Study

Investigation of temperature effects on wide steel box girder of suspension bridge based on long-term monitoring data

Influences of Wind Load on the Stability of Concrete Filled Steel Tube Arch Bridge in Construction

Strain-temperature Correlation Analysis of a Tied Arch Bridge Using Monitoring Data

Analysis of stability of long-span concrete filled steel tube arched bridge in construction

Nonlinear Stability Analysis of Long-span CFST Arch Bridge

Analysis of Influence of Tie Beam on Seismic Performance of Double Leg Thin-walled High Piers