Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

SNAP-THROUGH AND PULL-IN BEHAVIORS OF MEMS DEVICES WITH THE INITIAL CONFIGURATIONS

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Pull-In Dynamics of Two MEMS Parallel-Plate Structures for Acceleration Measurement

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Macro modeling method for electrostatic-drive silicon diaphragm

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Mechanical Behaviors of Electrostatic Microbeams with Nonideal Supports

Adhesion-Induced Failure of the Slender Mems Structures

Model of Electrostatic Actuated Deformable Mirror Using Strongly Coupled Electro-Mechanical Finite Element

Analysis and Computation of a Deformation of a Microbeam Driven by Electrostatic Force

Theoretical modeling and experimental investigation of in-phase resonant MEMS mirrors with cascaded structures

Unified Nonlinear Quasistatic and Dynamic Analysis of RF-MEMS Switches

Static and Dynamic Analysis of Electrostatically Actuated MEMS Shallow Arches for Various Air-Gap Configurations

An analytical model considering size effect for calculating the pull-in voltage of electrostatically actuated micro curled cantilever beams

Investigation of nonlinear squeeze-film damping involving rarefied gas effect in micro-electro-mechanical-systems

Nonlinear Transient Analysis for Large-Scale Dynamics of Microelectromechanical Systems with the MOR-PIM Method

Size-dependent pull-in voltage and nonlinear dynamics of electrically actuated microcantilever-based MEMS: A full nonlinear analysis

Dynamic Characteristics of Electrostatically Actuated Shape Optimized Variable Geometry Microbeam

A Variational Beam Model for MEMS Driven by Electrostatic and Piezoelectric Forces

Electromechanical Analysis of Microelectromechanical Structures and Dynamic Simulations of Laterally Vibratory Microgyroscope