Abstract:In this study, both the distribution of residual stress and welding deformation in a double-pass T-joint made of low-alloy ultra-high strength (UHS) quenched steel have been investigated experimentally and numerically. Using Abaqus software, the primary aim of this study is to develop an advanced computational approach incorporating a highly precise material model that accounts for solid-state phase transformation (SSPT) in the heat-affected zone (HAZ) and softening effect (SE) in the subcritical heat-affected zone (SCHAZ) to simulate residual stress and welding deformation in the double-pass T-joint. The predictions of welding thermal cycles, residual stress distribution, and welding deformation made by the finite element model have been validated against corresponding experimental results. When both SSPT and SE were considered in the finite element model, the predictions closely aligned with the experimental measurements. The experimental findings reveal that the maximum degree of softening in a T-joint subjected to double thermal cycles is more pronounced than in a T-joint subjected to a single thermal cycle. The simulation results indicate that SSPT significantly impacts both the magnitude and distribution of residual stress in the HAZ of the T-joint, while SE also can reduce the magnitude of longitudinal residual stress to a certain extent especially in SCHAZ. Furthermore, the simulation results suggest that SSPT moderately affects the distribution of longitudinal plastic strain in the double-pass T-joint, with minimal influence on angular distortion and transverse shrinkage. Additionally, the simulation results indicate that the SE has a limited impact on the welding deformation of the T-joint.

A Comparative Study of the Residual Deformation of an Automotive Gear-Case Assembly Due to Deep-Penetration High-Energy Welding

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Numerical Strength Analysis of Laser-Welded Differential Housing and Gear Considering Residual Stress

Numerical simulation and analysis of welding of drive axle housing and axle tube

Comparative Study of Welding Deformation of a Stiffened Panel under Various Welding Procedures

Review on finite element analysis of welding deformation and residual stress

FE analysis of residual stress and welding deformation of a low-alloy UHS quenched steel fillet joint

On Residual Stress and Relief for an Ultra-Thick Cylinder Weld Joint Based on Mixed Hardening Model: Numerical and Experimental Studies

Numerical Investigation on Evolution of Plastic Zone During Inertia Friction Welding Process of Ring Parts

Numerical Simulation of Weld Tab Length Influence on Welding Residual Stress and Distortion of Aero-Engine Disk

Determination of Welding Stress and Distortion in Discontinuous Welding by Means of Numerical Simulation and Comparison with Experimental Measurements

Numerical Analysis on Welding Deformation and Residual Stress of an Aluminum Alloy Floor of EMU Bodywork

Numerical Simulation for Full-Penetration Electron Beam Welding of Ti2AlNb Alloy

Study on FEM Numerical Simulation Method for the Welding Distortion

Evaluation Method for Inherent Deformation and its Application in Predicting Welding Distortion on Hull Blocks

Numerical Investigation on Stress Distribution and Evolution in 9cr/2.25cr Dissimilar Welded Rotor Undergoing Welding and Heat Treatment

Numerical Simulation of Residual Stresses in Multipass Gas Metal Arc-Welded Joints of Thick Aluminum Alloy Plates

Influence of welding sequences and boundary conditions on residual stress and residual deformation in DH36 steel T-joint fillet welds

Residual Stress Modeling of Narrow Gap Welded Joint of Aluminum Alloy by Cold Metal Transferring Procedure

Finite Element Prediction of Residual Stress and Deformation Induced by Double-Pass TIG Welding of Al 2219 Plate