Abstract:The feasibility of the idea of double stack HR coating was discussed in this paper both in theory and experiment. The theoretical simulation was made by employing optical coating design software. The analysis results showed that the design of double stack HR coating was feasible, which made the HR coating have ascendancy not only at reflectance but also at laser damage resistance. Then, the LaF3/MgF2 HR coating, the HfO2/SiO2 HR coating and the double stack HR coating were prepared for comparison, respectively. Transmittance spectra, surface morphologies and damage morphologies of these coatings were measured. Measurement of laser-induced damage threshold (LIDT) of S polarized light of the samples was performed at 355nm, 45° incidence. The measurement results showed that the LIDT value of the LaF3/MgF2 HR coating with 30 layers was very high, but the reflectance was low. When the layer number was increased up to 36, lots of cracks appeared on the surface of the LaF3/MgF2 HR coating, with the LIDT badly declining. It was thought that the residual stress resulted in the cracks and the decline of the LIDT. The spectra measurement showed the double stack HR coatings could provide higher reflectance and wider reflection band than LaF3/MgF2 HR coating with less layer pairs. Any crack was also not found on the surface of the double stack coatings. Meanwhile, the double stack HR coatings possessed greater laser damage resistances than the HfO2/SiO2 HR coating. The damage morphologies showed that the damage of the double stack coating was even milder than that of the HfO2/SiO2 coating. Therefore, the double stack design was effective to gain high reflectance and great UV laser radiation resistance simultaneously.

Zro2-Sio2 Coatings For Wavelength-Selective Reflection Filter

A novel trilayer antireflection coating using dip-coating technique

Sol–gel Derived ZrO2–SiO2 Highly Reflective Coatings

Sol-Gel Processing of Zirconia Coating for HR Mirrors with High Laser Damage Threshold

Fabrication of Sol–gel Derived ZrO 2 Thin Film for HR Coatings Via Rapid Thermal Annealing Process

Hard Antireflective Coatings in the Visible Band

Preparation of Sol–gel ZrO2–SiO2 Highly Reflective Multilayer Films and Laser-Induced Damage Threshold Characteristic

ZrO2 thin films and ZrO2/SiO2 optical reflection filters deposited by sol–gel method

Preparation of Zirconia Thin Films Via Sol-Gel Process from Inorganic Precursor

Sol-gel Processing of ZrO2 and Polymer Doped-Zro2 Monolayer Reflective Films with High Laser Damage Threshold

Sol-gel Preparation of a Silica Antireflective Coating with Enhanced Hydrophobicity and Optical Stability in Vacuum

Preparation of ZrO_2/SiO_2 Multilayer Films Via Chemical Methods

PREPARATION OF OPTIC FILM WITH HIGH REFRACTIVE INDEX BY CHEMICAL METHODS

Sol–gel Preparation and Characterization of Nanoporous ZnO/SiO2 Coatings with Broadband Antireflection Properties

A Design with High Spectral Efficiency and High Laser Induced Damage Threshold for 1064nm Partially Reflective Coatings

Fabrication of micro hole array on the surface of CVD ZnS by scanning ultrafast pulse laser for antireflection

A Hydrophobic Ultralow Refractive-Index Silica Coating Towards Double-Layer Broadband Antireflective Coating with Exceptionally High Vacuum Stability and Laser-Induced Damage Threshold

Enhanced antireflective and laser damage resistance of refractive-index gradient SiO2 nanostructured films at 1064 nm

Study on the Feasibility of Double Stack High Reflector Coating at 355Nm

Design and Sol–gel Preparation of a Six-Layer Tri-Wavelength ORMOSIL Antireflective Coating for a High Power Laser System

Surface-reliefed Gratings Film with High Laser Damage Thresholds