Abstract:<p>Adhesive wear is a direct result of material removal from surface asperities in contact due to adhesive forces. While macroscopic experiments confirmed the existence of a linear wear relation, referred to as Archard's wear relation (i.e. wear volume varies linearly with the normal load and sliding distance), recent small-scale wear experiments and simulations have questioned the validity of Archard's wear relation at the asperity level. We perform systematic long-timescale asperity-level wear simulations using two recently developed coarse-grained model potentials with extremely brittle and ductile behavior. A linear wear relation can be recovered from our simulations only when the material removal progresses by plastic deformation at the asperity tip, confirming the long-standing theoretical hypothesis made by Archard. However, this linearity breaks down when cleavage cracking dominates the material removal. As a result, we hypothesize that the breakdown of Archard's wear relation observed in previous numerical simulations and AFM experiments can be associated with the activation of other removal mechanisms than plastic deformation (e.g. asperity cracking or atomic attrition) and/or an inaccurate measurement of the normal load carried by the junction and the effective sliding distance (i.e. contact time). Supporting basic theoretical assumptions made by Archard, future studies should focus on up-scaling the mechanics of single-asperity to a multi-asperity contact to calculate the wear coefficient as the probability of material removal from asperity encounters.</p>

An experimental simulation of cutting wear in three-body abrasion

Molecular Dynamics Simulation of Micro Cutting Process of Abrasive Wear

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Novel three-body nano-abrasive wear mechanism

A study of abrasive wear under three-body conditions

Contact Analysis of Abrasive Wear

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

Wear at an incipient ploughing–cutting transition

A story of two transitions: From adhesive to abrasive wear and from ductile to brittle regime

Effect of In-Situ (ti&w)c Multiphase Particles on Three-Body Abrasive Wear of High Chromium Cast Iron

Micromechanics of material detachment during adhesive wear: A numerical assessment of Archard's wear model

Hardness Effect on Three-Body Abrasive Wear Under Fluid Film Lubrication

Three-body abrasion behavior of ultrafine WC–Co hardmetal RX8UF with carborundum, corundum and silica sands in water-based slurries

Wear simulation of UHMWPE against the different counterface roughness in reciprocating unidirectional sliding motion

Study on Simulation of Coupled Heat Transfer, Stress and Wear Behavior in Pin-on-disc Experiments

Interaction between partial-worn TBM cutters and rocks: experimental and numerical investigation

Wear and damage transitions of two kinds of wheel materials in the rolling-sliding contact

Modeling Analysis of Abrasive Wear

Research on the Wear of Groove Structured Grinding Wheel Based on the Simulation and Experiment of Single Abrasive Particle Scratching

From atomic attrition to mild wear at multi-asperity interfaces: The wear of hard Si3N4 repeatedly contacted against soft Si