Abstract:This paper investigates the effect of the variation in alkoxide precursor ratio and templating agent concentration on the production of titanium silicalite (TS-1) through analysis using various physical characterisation techniques. X-ray diffraction showed clear evidence for the MFI zeolite structure and a high degree of crystallinity in all systems. For those materials prepared using a templating agent with ultra low alkali metal content, excellent agreement with previously reported unit cell parameters was obtained. For these same systems, 20% higher specific surface areas were also obtained by nitrogen adsorption. Analysis using an energy dispersive x-ray spectrometer coupled to a scanning electron microscope showed that the product typically contained between 60 and 90% of the titanium in the precursor and some dependence of titanium incorporation on the initial mixture composition was also observed. The results from Raman spectroscopy indicated titanium incorporation into the silicalite framework for all systems. For those materials produced using a templating agent with low alkali metal content, extra-framework anatase titanium dioxide was also identified at moderate Ti : Si mole ratios (>0.03) in the initial mixture. Due to its lower penetration depth, x-ray photoelectron spectroscopy (XPS) was used to characterise the titanium species in the surface layer. The XPS results indicated that a small amount of extra-framework titania was present in the surface of most of the TS-1 samples and the proportion of extra-framework material was observed to increase with both precursor alkali metal content and precursor titanium to silicon ratio.

Synthesis of Plate Like Silicalite-1 with Controlled Thickness

Effects of Impurity Ions on the Synthesis of Hollow Silica

Preparation of Aluminosilicate Ferrierite Zeolite Nanosheets with Controllable Thickness in the Presence of a Sole Organic Structure Directing Agent

Platelike MFI Crystals with Controlled Crystal Faces Aspect Ratio

Control of crystallization rate and morphology of zeolite silicalite-1 in solvent-free synthesis

Rapid and Facile Synthesis of Nanosized Silicalite-1 Zeolites from Solid Silica in a Semisolid-like System Via a Two-Step Crystallization Method

Vapor Phase Transport Synthesis and Structure Characterization of an Aluminophosphate Molecular Sieve [Al3P3O12F][C5H5NH]center dot 0.2H(2)O

Cooperative Structure-Directing Effects in the Synthesis of a Low-Silica Zeolite Phillipsite Analogue

Stable Ordered Mesoporous Silica Materials Templated by High-Temperature Stable Surfactant Micelle in Alkaline Media

Synthesis of titanium silicalite-1 using amorphous SiO2 as silicon source

Transformation of Lamellar Silicate into the Mesoporous Molecular Sieve MCM-41

Synthesis of Aluminosilicate MCM-41 Using Oligomeric Surfactant As Template

From nano aggregates to nano plates: The roles of gelatin in the crystallization of titanium silicate-1

Size-controlled Synthesis of Silicalite-1 Nanocrystals

Hierarchical Structure of SiO2 by In Situ Modification Combining Quartz Sand and Methyltrimethoxysilane

Direct synthesis of hydrothermally stable micro–mesoporous silicas templated by unsaturated α-linolenic acid self-assemblies under high temperature hydrothermal conditions

High temperature synthesis of hydrothermally stable micro-mesoporous silica and Al-doped mesoporous silica via rigid template

Nonionic Block Copolymer and Anionic Mixed Surfactants Directed Synthesis of Highly Ordered Mesoporous Silica with Bicontinuous Cubic Structure

The synthesis and characterization of titanium silicalite-1

Synthesis of ordered small pore mesoporous silicates with tailorable pore structures and sizes by polyoxyethylene alkyl amine surfactant

Characterization of Nanosized Material Extracted from Clear Suspensions for MFI Zeolite Synthesis